GE JGSP28 warranty

Installation Instructions

Gas Slide-In Range

JGSP28

Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: www.GEAppliances.com

IN THE COMMONWEALTH OF MASSACHUSETTS:

•This product must be installed by a licensed plumber or gas fitter.

•When using ball-type gas shut-off valves, they shall be the T-handle type.

•A flexible gas connector, when used, must not exceed 3 feet.

PARTS INCLUDED

Screws Anti-Tip Bracket

Rear Filler

2 Screws

BEFORE YOU BEGIN

Read these instructions completely and carefully.

•IMPORTANT — Save these

instructions for local inspector’s use.

•IMPORTANT — Observe all governing codes and ordinances.

•Note to Installer – Be sure to leave these instructions with the Consumer.

•Note to Consumer – Keep these instructions for future reference.

•Product failure due to improper installation is not covered under the Warranty.

WARNING — This appliance must be properly grounded.

•IMPORTANT — Leak testing of the appliance shall be conducted according to the manufacturer’s instructions.

•Proper installation is the responsibility of the installer and product failure due to improper installation is NOT covered under warranty.

MATERIALS YOU MAY NEED

Joint Sealant Pipe Fittings Shut Off Valve

CSA-Approved Flexible Gas Line

3/8″ Min. ID, 1/2″ NPT Connection,

3-foot Maximum Length (Massachusetts Only)

TOOLS YOU WILL NEED

1/4” Nut Driver Level

Phillips Head	Pipe Wrench
Screwdriver

Tape Measure	Wrench or Pliers
	(for 1-7/16” Nut)

Safety Glasses Drill

229C4053P596

31-10598 10-04 JR

1