GE JGSP28 warranty Important Safety Instructions, For Your Safety, What to do if YOU Smell GAS

Page 2

Installation Instructions

IMPORTANT SAFETY INSTRUCTIONS

FOR YOUR SAFETY:

WARNING — If the information in this manual is not followed exactly, a fire, explosion or gas leak may result, causing property damage, personal injury or death.

Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance!

WHAT TO DO IF YOU

SMELL GAS:

Do not try to light any appliance. Do not touch any electrical switch; do not use any phone in your building.

Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

If you cannot reach your gas supplier, call the fire department.

Installation and service must be performed by a qualified installer, service agency or the gas supplier.

This range has been design certified by UNDERWRITERS LABORATORIES. You’ll find safety precautions in your Owner’s Manual. Read them carefully.

Installation of this range must conform with local codes or in the absence of local codes with the National Fuel Gas Code, ANSI Z223.1–Latest edition.

Be sure your range is installed properly by a qualified installer or service technician.

To eliminate reaching over surface burners, cabinet storage above burner should be avoided.

Do not install the unit near an outside door or where a draft may affect its use.

2

Image 2
Contents JGSP28 What to do if YOU Smell GAS Important Safety InstructionsFor Your Safety Electrical Requirments ANTI-TIP DeviceProtect the Kitchen Floor PRE-INSTALLATION ChecklistCAREFULLY, Tilt Range to Access Range Leveling Legs Remove Storage Drawer Remove the Door if NecessaryRemove the Door if Necessary PRE-INSTALLATION Cutout and Required Clearances Standard InstallationINSTALLATION-ELECTRICAL Connections Electrical ConnectionsMaking the Connections GAS ConnectionsMaking the Connections Install the ANTI-TIP Bracket Install the RangeInstall the ANTI-TIP Bracket Install the Bracket in Wood or ConcreteFinal Check of ANTI-TIP Bracket Slide Range Into OpeningSlide Range Into Opening Replace the Oven Door Replace the Storage DrawerAssemble the Burners Cooktop BurnersCooktop Burners Check for LeaksBurner Ignition Pressure Test InformationCheck the Igniters Burner FlamesChecking the Oven Burners Adjust the AIR ShutterBake and Broil Burners Optional Maintop Filler or Backguard KIT For NON-BUILT-IN Installation END of Cabinet LocationIsland Installation Some Cases Operation ChecklistAdjusting LOW Flame Setting on Cooktop Burners For Cabinet Openings Approximately 30-3/8″
Related manuals
Manual 36 pages 38.56 Kb Manual 36 pages 39.67 Kb