Installation Instructions
ELECTRICAL REQUIRMENTS
This appliance must be supplied with the proper voltage and frequency and connected to an individual, properly grounded branch circuit, protected by a circuit breaker or fuse having amperage as noted on the rating plate. (Rating plate is located above the storage drawer below the oven frame).
We recommend you have the electrical wiring and hookup of your range connected by a qualified electrician. After installation, have the electrician show you where your main range disconnect is located.
Check with your local utilities for electrical codes which apply in your area. Failure to wire your range according to governing codes could result in a hazardous condition. If there are no codes, your range must be wired and fused to meet the requirements of the National Electrical Code, ANSI/NFPA No.
National Fire Protection Association
Batterymarch Park
Quincy, MA 02269
Be sure the installation of this product in a mobile home conforms with the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280. If this standard does not apply, you must follow the standard for Manufactured Home Installations, ANSI A225.1 and Manufactured Home Installations, Sites and Communities and ANSI/NFPA 501A or with local codes. You can get a copy of the Federal Standard by Writing:
Office of Mobile Home Standards
HUD Building
451 7th Street, S.W.
Washington, D.C. 24010
ANTI-TIP DEVICE
WARNING — To reduce the risk of tipping, the appliance must be secured by properly installed
To check if the bracket is installed and engaged properly, carefully tip the range forward. The
WARNING —
• All ranges can tip
•Injury to persons could result
•Install
• See Installation Instructions
If you pull the range out and away from the wall for any reason, make sure the
3