GE JGSP28 warranty Slide Range Into Opening, Final Check of ANTI-TIP Bracket

Page 10

Installation Instructions

INSTALL THE RANGE (CONT.)

13 SLIDE RANGE INTO OPENING

APosition the range in front of the cabinet opening.

BMake sure that the cooktop edges that overhang the countertop clear the countertop. If necessary, raise the unit by lowering the leveling legs.

CPush while lifting the range into the opening, until the range is within 2″ of engaging the anti-tip bracket.

DRemove the protective trim from the side of the cooktop (if provided).

EUsing the adjustable pliers or wrench, carefully screw in the back leveling leg until the cooktop overhang comes to rest on the countertop.

Adjustable wrench or pliers

FCarefully screw in the front two leveling legs (similar to Step E) until the cooktop overhang touches the countertop.

GCarefully push the range into the opening until the anti-tip bracket engages and the vertical sides are flush with the cabinet.

13SLIDE RANGE INTO OPENING (cont.)

HPlug the range cord into the receptacle. Locate the cord in the back of the range in a manner that it will not touch or be moved by the drawer.

Position range cord so that there is no interference with storage drawer

STORAGE DRAWER

14FINAL CHECK OF ANTI-TIP BRACKET

When installation is complete and the range is in place, check to be sure that the rear leveling leg is fully inserted into the slot of the Anti-Tip Bracket.

Countertop

Cabinet

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents JGSP28 For Your Safety Important Safety InstructionsWhat to do if YOU Smell GAS Electrical Requirments ANTI-TIP DeviceCAREFULLY, Tilt Range to Access Range Leveling Legs PRE-INSTALLATION ChecklistProtect the Kitchen Floor Remove the Door if Necessary Remove the Door if NecessaryRemove Storage Drawer PRE-INSTALLATION Cutout and Required Clearances Standard Installation INSTALLATION-ELECTRICAL Connections Electrical ConnectionsMaking the Connections GAS ConnectionsMaking the Connections Install the ANTI-TIP Bracket Install the RangeInstall the ANTI-TIP Bracket Install the Bracket in Wood or ConcreteSlide Range Into Opening Slide Range Into OpeningFinal Check of ANTI-TIP Bracket Replace the Oven Door Replace the Storage DrawerAssemble the Burners Cooktop BurnersCooktop Burners Check for LeaksBurner Ignition Pressure Test InformationCheck the Igniters Burner FlamesBake and Broil Burners Adjust the AIR ShutterChecking the Oven Burners Island Installation For NON-BUILT-IN Installation END of Cabinet LocationOptional Maintop Filler or Backguard KIT Some Cases Operation ChecklistAdjusting LOW Flame Setting on Cooktop Burners For Cabinet Openings Approximately 30-3/8″
Related manuals
Manual 36 pages 38.56 Kb Manual 36 pages 39.67 Kb
Top Page Image Contents