Automatic Oven Timer, Tones, How to Change a Program

Automatic Oven Timer

The oven timer will automatically start and stop your oven cooking or self-cleaning operation for you.

For automatic oven cooking:

1.Push COOK TIME button.

2.Turn SET knob to set length of baking time.

3.Push BAKE button.

4.Turn SET knob to set desired temperature.

When cook time is reached, the End-of-Cycle Tone will sound and the oven will turn off.

During automatic cooking:

●You can push the STOP TIME button to find out when the End-of- Cycle Tone will sound and the oven will turn off.

. You can push the CLOCK button to display time of day without canceling the oven operation.

To Delay Starting an Automatic Oven Operation

If a delayed cooking operation is desired:

1.Push COOK TIME button.

2.Set length of baking time with

SET knob.

3.Push STOP TIME button.

4.Turn SET knob to time of day when baking should be completed.

Stop time must be equal to or greater than the cook time plus the current time of day.

5. Push BAKE button.

6 Turn SET knob to desired temperature.

When stop time is reached, the End-of-Cycle Tone will sound and the oven will turn off.

Caution: Never let food sit in the oven for more than 4 hours before cooking starts. Room temperature is ideal for the growth of harmful bacteria. Be sure oven light is off because heat from the bulb will

sDeed bacteria m-owth.

Note: You can push the STOP TIME button to find out when the oven will turn off. Push and hold the COOK TIME button to find out when the oven will turn on.

If a delayed self-cleaning oven operation is desired, see page 21.

How to Change a Program

When a function has been entered, you can recall what has been programmed by pushing the corresponding function button. The messages in the display show you which fimction is currently being displayed. While the function is displayed, you can change it with the SET knob. You can change any programmed function at anytime.

Tones

End-of-Cycle Tone (3 long beeps– one second on, one second off): shows that a timed oven operation has reached SKIP TIME or that the Minute/Second Timer has counted down.

Attention Tone (series of short beeps, l/4-second on, l/4-second off, until proper response is given): will sound if oven has only been partially programmed. For example, if you have selected a cook time but no temperature, you will hear the Attention Tone until you select a temperature or push CANCEL.

Notification Tone (single, one- second beep): indicates oven has stabilized at selected temperature.

Key Tone (single, l/10-second beep): sounds when any button is pushed.

Function Error Tone (series of very rapid beeps, l/8-second on, l/4-second off.): display will show a failure code. Cancel Function Error Tone by pushing the CANCEL button. If the Function Error Tone starts again (after about 15 second;), call for service. Disconnect the range electrical supply to stop the tone.

If the function error occurred while you were rn-om-amming the Electr&ic Con{rolUpush the- CANCEL button and try again.

To Cancel the Tone... If you don’t want an audible tone when you push a button, you can eliminate the Key Tone by pushing and holding the CANCEL button until you hear a short beep (in approximately two seconds). To activate the tone again, push and hold the CANCEL button once more until you hear a short beep. Canceling or activating the tone should only be done when there is no oven operation programmed.

Pushing the CANCEL button will clear all functions except the Clock and Minute/Second Timer.