❑SEAL THE OPENINGS
Seal any openings in the wall behind the range and in the floor under the range when hookups are completed.
E LIGHT THE PILOTS
(for Models Equipped with Standing Pilots)
The range should be installed in its permanent position before any pilots are lit or adjusted.
Light the Sutiace Burner Pilots
CA~ON: Make sure the surface burner control knobs are in the OFF position before attempting to light the pilots.
1.Raise the cooktop.
2.Light both pilots with a match.
3.To avoid pilot outage, use caution when closing cooktop after lighting pilots.
NO~: Do not leave standing pilot lit in a newly constructed or remodeled home or apartment that will be unoccupied for more than a month.
Each pilot flame was adjusted at the factory to be approximately 5/16” tall. A tinge of yellow appearing at the upper tip is normal. If you find pilot adjustment is necessary, follow instructions at right.
Adiust the Surface Burner Pilots if Necessa~
of the manifold panel.
3.To adjust, use a
Light the Oven Pilot
CA~ON: Make sure the OWN CONTROL knob is in the OFF position before attempting to light the pilot.
1.Remove the broiler drawer by sliding the drawer all the way out and then lifting slightly to remove it from it’s tracks.
2.hcate the pilot at the
back of the broiler compartment. The pilot is attached to the left side of the oven burner.
3.Light the pilot with a match. No adjustments ar required for natural gas. For LP gas, see How to Convert the Range for Use with LP Gas or Natural Gas section.
(continued next page)
35