Sherwood R-765 Adjusting each channel level with test tone, Adjusting the current channel level

Adjusting each channel level with test tone

• The volume level of each channel can be adjusted easily with the test tone function.

Note : When the 7 CH DIRECT is selected as an input source, the SPEAKER button is set to off or it is in the stereo mode, the test tone function does not work.

1	Enter the test tone mode.	• The test tone will be heard from the speaker of each
		channel for 2 seconds as follows:
	T/V		FL	C	FR	SR	SB	SL
		Front Left		Center	Front Right	Surround	Surround	Surround
						Right	Back	Left
	T.TONE				SW
					Subwoofer
		• When the speaker setting is “N”, the test tone of the
		corresponding channel is not available.
2	At each channel, adjust the level as desired	3	Cancel the test tone function.
	until the sound level of each speaker is heard
	to be equally loud.
	ADJUST						T/V
	CH/LEVEL
	T/V		T.TONE
	or

•You can select the desired channel and adjust its level with repeating the steps 1 and 2 in “Adjusting each channel level” procedure.

Adjusting the current channel level

•After adjusting each channel level with test tone, adjust the channel levels either according to the program sources or to suit your tastes.

1	Press the CHANNEL SELECTOR button.	• “REF. 1”(or “USER”, etc.) is displayed and each
	CHANNEL	time this button is pressed, the corresponding channel
	SELECTOR	is selected and displayed for several seconds as
	CH.SEL	follows:
	T/V
	or	FL	C	FR	SR	SB
		( DTS L	DD L )		SW	SL
		DTS LFE	Dolby Digital LFE
		( ) : impossible when the analog input is selected as
		signal input.

•You can adjust the LFE level for Dolby Digital or DTS program source that includes LFE signal.

•When it is in the stereo or Dolby Virtual mode or the speaker setting is “N”, center, surround L/R, surround back or subwoofer channel will not be selected.

•When the SPEAKER button is set to off, only the front L/R channel can be selected.

29