GE JgB290, JgB280 Using the oven controls, Safety Instructions, Care, Installation Instructions

Page 10

Safety Instructions

 

Operating Instructions

 

Cleaning

Using the oven controls.

Throughout this manual, features and appearance may vary from your model.

Oven Control, Clock and Timer Features and Settings (on some models)

Care and

 

Installation Instructions

 

Bake/Temp Recall Pad

Touch this pad to select the bake function.

Bake Light

Flashes while in edit mode—you can change the oven temperature at this point. Glows when the oven is in bake mode.

Start/On Pad

Must be touched to start any cooking or cleaning function.

Display

Shows the time of day, oven temperature, whether the oven is in the bake, broil or self-cleaning mode and the times set for the timer or automatic oven operations. The display will show PRE while preheating. When the oven reaches the selected temperature, the oven control will beep and the display will show the oven temperature.

Kitchen Timer On/Off Pad

Touch this pad to select the timer feature.

Then press the + and – pads to adjust the timer.

Timer Light

Flashes while in edit mode—you can change the set time at this point. Glows when the timer has been activated. Flashes again when the time has run out until the control is reset.

Clock Pad

To set the clock, press this pad twice and then press the + and – pads. The time of day will flash in the display when the oven is first turned on.

Start Time Pad (on some models)

Use along with the Cooking Time or Self Clean pads to set the oven to start and stop automatically at a time you set.

Troubleshooting Tips

 

Consumer Support

 

 

If “F–” and a number or letter flash in the display

 

and the oven control signals, this indicates a function

 

error code.

 

If your oven was set for a timed oven operation

 

and a power outage occurred, the clock and all

 

programmed functions must be reset.

 

The time of day will flash in the display when there

 

has been a power outage. Reset the clock.

 

If the function error code appears during the

 

self-cleaning cycle, check the oven door latch. The

 

latch handle may have been moved, even if only

 

slightly, from the latched position. Make sure the

 

latch is moved to the right as far as it will go.

 

Touch the Clear/Off pad. allow the oven to cool

 

for one hour. Put the oven back into operation.

10

If the function error code repeats, disconnect

the power to the range and call for service.

Start Time Light

Flashes while in edit mode—you can change the start time at this point. Glows when the function has been activated.

Cooking Time Pad (on some models)

Touch this pad and then touch the + or – pads to set the amount of time you want your food to cook. The oven will shut off when the cooking time has run out.

Cooking Time Light

Flashes while in edit mode—you can change the set time at this point. Glows when the function has been activated. Flashes again when the time has run out until the control is reset.

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Write the model and serial numbers here Model # Serial # To reduce the risk of tipping the range, the range must Be secured by a properly installed anti-tip bracket. SeeDetails before attempting to install Range within 4 inches. If it does not, the bracket must beIMPORTaNT SaFeTY NOTICe GEAppliances.comAppliance as a space heater to heat or SURFaCe BURNeRS Cook MeaT aND Poultry THOROUgHLY… Operating InstructionsOperatingInstructions Care and Cleaning ELeCTRIC WaRMINg DRaWeR on some modelsCare and Cleaning Using the gas surface burnersSafety Installation Instructions Troubleshooting TipsTop-of-Range Cookware Case of Power FailureCare Installation Instructions Using the oven controlsSafety Instructions CareTouch this pad to turn the oven light on or off Safety InstructionsOr temperature by larger amounts Touch this pad to select the broil functionBefore you begin… Troubleshooting TipsOven Vent Care and Cleaning Installation Instructions Using the upper ovenSupport Hi Broil How to Set the Oven for BroilingPlace the meat or fish on a broiler grid in a broiler pan To change to Lo Broil, touchTo Set the Timer Using the clock and timer. on some modelsCleaning To Set the ClockPower Outage To Reset the TimerTo Cancel the Timer Touch the Kitchen Timer On/Off pad twiceHow to Set an Immediate Start and Automatic Stop How to Set a Delayed Start and Automatic StopSpecial features of your oven control. on some models If you wish to turn OFF this feature, follow the steps belowCare and Cleaning Installation Instructions Using the Sabbath feature. on some modelsHow to Set for Regular Baking/Roasting Designed for use on the Jewish Sabbath and HolidaysHow to Exit the Sabbath Feature Touch the Clear/Off padTo Adjust the Thermostat on some models Adjust the oven thermostat-Do it yourselfInstallation Troubleshooting InstructionsTips To Adjust the Thermostat on models with an Oven Temp KnobOn Signal Light Using the warming drawer. on some modelsWhen Using the Warming Drawer Push and turn the control knob to any desired settingTo Crisp Stale Items Temperature Selection ChartTo Warm Serving Bowls and Plates How to Set the Oven for Cleaning Using the self-cleaning ovenBefore a Clean Cycle ConsumerTo Stop a Clean Cycle on some models How to Delay the Start of Cleaning on some modelsAfter a Clean Cycle on some models Burner Grates Care and cleaning of the rangeOperating BurnersInstructions Installation Standard Twin Burner Assemblies on some modelsBurner Caps and Heads Cooktop Surface Tips TroubleshootingOperating Instructions Oven Air VentsOven Bottom To clean the inside of the doorLift-Off Oven Door Oven frame, pull them back outRemovable Storage Drawer on some models Removable Kick Panel on some modelsRemovable Warming Drawer on some models Oven Racks Oven Light ReplacementLower Control Panel Front Manifold Panel and Knobs Do not remove any screws to remove the coverMaterials yoU MAy Need FoR yoUR SAFETyTooLS yoU wILL Need Gas line shut-off valveInstallation Instructions DIMENSIoNS and Clearances ANTI-TIP Device LoCATIoNPRoVIDE ADEqUATE GAS SUPPLy CoNNECT the Range To GASRange hookup Alternate Hookup Pressure regulator Manifold pipe Electrical CoNNECTIoNS Power cord of this appliance is equipped with aAn adapter may be used only on a 15-amp circuit Check IGNITIoN oF oVEN Burner Seal the oPENINGSCheck IGNITIoN oF Surface Burners With LP gas, some yellow tipping on outer cones is normalIf NECESSARy OtherInstalling the ANTI-TIP Device WHEN ALL HooKUPS are CoMPLETEDBefore you call for service… Problem Possible Causes What To DoFood does not bake Oven controls improperly set Oven will not self-clean Oven temperature is tooHigh to set a self-clean operation Or roast properly Rack position is incorrectDoor appears Self-cleaning cycle has been Self-clean light on Oven Temp knob has notDuring self-clean cycle During the self-cleaning cycleUnable to get Oven control pads were Power outage Power outage or surgeDisplay goes blank Fuse in your home may be Display to show SF Not touched properlyAccessories Limited Time Offer! Free ShippingFor The Period GE Will ReplaceWhat GE Will Not Cover Warrantor General Electric Company. Louisville, KYWhat Mabe Will Not Cover Mabe Will ReplaceWarrantor Mabe Canada Inc Burlington, Ontario Schedule Service Consumer Support
Top Page Image Contents