GE JgB290, JgB280 manual Burner Caps and Heads

Page 28

Care and cleaning of the range.

Troubleshooting InstallationOperating Consumer Support Tips Instructions Care and Cleaning Instructions

Use a sewing needle or twist-tie

to unclog the small hole in the burner head.

Burner Caps and Heads

NOTE: Before removing the burner caps and heads, remember their size and location. Replace them in the same location after cleaning.

Burner caps

Lift off when cool. Wash burner caps

in hot, soapy water and rinse with clean water. You may scour with a plastic scouring pad to remove burned-on food particles.

Burner heads

For proper ignition, make sure the small hole in the section that fits over the electrode is kept open. A sewing needle or wire twist-tie works well to unclog it.

The slits in the burner heads must be kept clean at all times for an even, unhampered flame.

Clogged or dirty burner ports or electrodes will not allow the burner to operate properly.

Any spill on or around an electrode must be carefully cleaned. Take care to not hit an electrode with anything hard or it could be damaged.

You should clean the burner caps and burner heads routinely, especially after bad spillovers, which could clog the openings in the burner heads. Lift off when cool.

To remove burned-on food, soak the burner heads in a solution of mild liquid detergent and hot water for 20–30 minutes. For more stubborn stains, use a toothbrush.

After cleaning

Before putting the burner caps and heads back, shake out excess water and then dry them thoroughly by setting in a warm oven for 30 minutes.

NOTE: Do not use steel wool or scouring powders to clean the burners.

Replacement

Replace burner heads over the electrodes on the cooktop, in the correct locations according to their size.

On some models:

Medium head

Small head

and cap

and cap

	Front of range
Large head	Large		head

and cap	and cap

On some models:

Medium head

Small head

and cap

and cap

	Front of range

Medium head	Large head
and cap	and cap

Make sure the slot in the burner head is positioned over the electrode.

Replace the matching size caps onto the heads.

Make sure that the heads and caps are replaced in the correct locations.

NOTE: On some models, the burners are all the same size and power.

28

Image 28

Contents Write the model and serial numbers here Model # Serial # Be secured by a properly installed anti-tip bracket. See Details before attempting to installTo reduce the risk of tipping the range, the range must Range within 4 inches. If it does not, the bracket must beIMPORTaNT SaFeTY NOTICe GEAppliances.comAppliance as a space heater to heat or SURFaCe BURNeRS Cook MeaT aND Poultry THOROUgHLY… Operating InstructionsOperatingInstructions Care and Cleaning ELeCTRIC WaRMINg DRaWeR on some modelsUsing the gas surface burners SafetyCare and Cleaning Installation Instructions Troubleshooting TipsTop-of-Range Cookware Case of Power FailureCare Using the oven controls Safety InstructionsInstallation Instructions CareSafety Instructions Or temperature by larger amountsTouch this pad to turn the oven light on or off Touch this pad to select the broil functionBefore you begin… Troubleshooting TipsOven Vent Care and Cleaning Installation Instructions Using the upper ovenSupport How to Set the Oven for Broiling Place the meat or fish on a broiler grid in a broiler panHi Broil To change to Lo Broil, touchUsing the clock and timer. on some models CleaningTo Set the Timer To Set the ClockTo Reset the Timer To Cancel the TimerPower Outage Touch the Kitchen Timer On/Off pad twiceHow to Set an Immediate Start and Automatic Stop How to Set a Delayed Start and Automatic StopSpecial features of your oven control. on some models If you wish to turn OFF this feature, follow the steps belowUsing the Sabbath feature. on some models How to Set for Regular Baking/RoastingCare and Cleaning Installation Instructions Designed for use on the Jewish Sabbath and HolidaysHow to Exit the Sabbath Feature Touch the Clear/Off padAdjust the oven thermostat-Do it yourself Installation Troubleshooting InstructionsTipsTo Adjust the Thermostat on some models To Adjust the Thermostat on models with an Oven Temp KnobUsing the warming drawer. on some models When Using the Warming DrawerOn Signal Light Push and turn the control knob to any desired settingTo Crisp Stale Items Temperature Selection ChartTo Warm Serving Bowls and Plates Using the self-cleaning oven Before a Clean CycleHow to Set the Oven for Cleaning ConsumerTo Stop a Clean Cycle on some models How to Delay the Start of Cleaning on some modelsAfter a Clean Cycle on some models Care and cleaning of the range OperatingBurner Grates BurnersInstructions Installation Standard Twin Burner Assemblies on some modelsBurner Caps and Heads Tips Troubleshooting Operating InstructionsCooktop Surface Oven Air VentsTo clean the inside of the door Lift-Off Oven DoorOven Bottom Oven frame, pull them back outRemovable Storage Drawer on some models Removable Kick Panel on some modelsRemovable Warming Drawer on some models Oven Light Replacement Lower Control Panel Front Manifold Panel and KnobsOven Racks Do not remove any screws to remove the coverFoR yoUR SAFETy TooLS yoU wILL NeedMaterials yoU MAy Need Gas line shut-off valveInstallation Instructions DIMENSIoNS and Clearances ANTI-TIP Device LoCATIoNPRoVIDE ADEqUATE GAS SUPPLy CoNNECT the Range To GASRange hookup Alternate Hookup Pressure regulator Manifold pipe Electrical CoNNECTIoNS Power cord of this appliance is equipped with aAn adapter may be used only on a 15-amp circuit Seal the oPENINGS Check IGNITIoN oF Surface BurnersCheck IGNITIoN oF oVEN Burner With LP gas, some yellow tipping on outer cones is normalIf NECESSARy OtherInstalling the ANTI-TIP Device WHEN ALL HooKUPS are CoMPLETEDBefore you call for service… Problem Possible Causes What To DoOven will not self-clean Oven temperature is too High to set a self-clean operationFood does not bake Oven controls improperly set Or roast properly Rack position is incorrectSelf-clean light on Oven Temp knob has not During self-clean cycleDoor appears Self-cleaning cycle has been During the self-cleaning cyclePower outage Power outage or surge Display goes blank Fuse in your home may beUnable to get Oven control pads were Display to show SF Not touched properlyAccessories Limited Time Offer! Free ShippingGE Will Replace What GE Will Not CoverFor The Period Warrantor General Electric Company. Louisville, KYWhat Mabe Will Not Cover Mabe Will ReplaceWarrantor Mabe Canada Inc Burlington, Ontario Schedule Service Consumer Support