GE JGBP26GEN, JGBP27GEN installation instructions When ml Hookups are COMPLETE~

Page 43

❑LEVELING THE RANGE

1.Remove the storage drawer, broiler drawer or kick panel.

2.Use a 3/16” open-end or socket wrench to back out both rear leveling legs approximately two turns.

3.Use a 1%” open-end or adjustable wrench to back out the front leveling legs two turns.

4.Install the oven shelves in the oven and position the range where it will be installed.

5.Check for levelness by placing a spirit level or a cup, partially filled with water, on one of the oven racks. E using a spirit level, take two readings—with the level placed diagonally first in one direction and then the other.

6.Adjust the leveling legs until the range is level.

7.After the range is level, slide the range away from the wall so that the Anti-Tip device can be installed.

❑INSTALLING THE ANTI-TIP DEVICE

WARNING:

●Range must be secured with an approved Anti-Tip device.

●Unless properly installed, the range could be tipped by you or a child standing, sitting or leaning on an open door.

●After installing the Anti-Tip device, verify that it is in place by carefully attempting to tilt the range forward.

●This range has been designed to meet all recognized industry tip standards for all normal conditions.

●The use of this device does not preclude tipping of the range when not properly installed.

●If the Anti-Tip device supplied with the range does not fit this application, use the universal Anti-Tip device WB02X7909.

1.Mark the wall where the NGHT EDGE of the range is to be located. Be sure to allow for the countertop overhang if you intend to install the range next to cabinets.

2.hcate the outside edge of the device 2%” toward the center of the range from the marked edge of the range.

3.Using the device as a template, mark the position of the hole for the screw.

4.For wood construction, drill a pilot hole at an angle of 20 degrees from the horizontal. A nail or awl may be used if a drill is not available.

Mount the kti-Tip device with the screw provided.

For cement or concrete construction, you will need a 1/4” x 1X” lag bolt and a 1/2” O.D. sleeve anchor, which are not provided. Drill the recommended size hole for the hardware.

Install the sleeve anchor into the drilled hole and then install the lag bolt through the device. The bolts must be properly tightened as recommended for the hardware,

Back of

Range

5.Slide the range against the wall, and check for proper installation by grasping the front edges of the rear surface unit openings and carefully attempting to tilt the range forward.

WHEN ml HOOKUPS ARE COMPLETE~

WE SURE~L ~NTROLSARE LEFT IN THE OFF POSITION.

-E SURE THE FLOW OF ~MBUSTION AND VENTIUTION NR TO THE RANGE IS UNOBSTRU~ED.

(contin[~ed next page)

43

Page 42 Page 44
Image 43
Page 42 Page 44
Contents 25-32 Operating Instructions, Tips33-48 Read this book carefully Save time and money. Before you request serviceIf ou received Jamaged range Using Your Range When You at Your RangeSurface Cooking Wortant Safety ~STRUCTIONSSave These Cleaning Your RangeSelf-Cleaning Oven If You Need ServiceJGBP26GEN JGBP27GEN JGBP31GEP JGBP34GEP JGBP35GEP FEATu~s of Your Range14, 15 +1!11 Suwace COOmGUse of Stove ToP Grills How to Select Flame SizeTop-of-Range Cookware Wok CookingClear Q-w Oven CONTROL, Clock Am T~R USmG Your OWN Suflace Light Adjusting Oven ThemostatOven Moisture Oven Ven@How to Set Immediate Start and Automatic Stop How to Set Your Range for BakingQuick Reminder How to Set Delay Start and StopPreheating Pan PlacementBA~G Oven ShelfAluminum Foil Baking GuidesCookies CakesDual Shelf Cooking For Frozen RoastiQuestions and Answers Should I salt the meat before broiling? Why are my meats not turning out as brown as they should?Use of Aluminum Foil Questions & AnswersBacon Oven Front Frame Oven Door Gasket Oven Light OPEMT~G the SELF-CLEANING OWNBefore a Clean Cycle How to Set Oven for CleaningHow to Delay Start of Cleaning After a Clean CycleQuick Reminder-Delay Start for Self-Clean My oven shelves do not slide easily. What is the matter? Is the crackling sound I hear during cleaning normal?Should there be any odor during the cleaning? Why do I have ash left in my oven after cleaning?Sealed Burner Assemblies on some models ~GrateCAm Am Cleaning Cooktop Sutiace Burner GratesLift-Off Oven Door CA~ Am CleaningInside of door Broiler Pan and Rack Oven BottomOven Lamp Replacement on some models CAm Am CleaningControl Panel and Knobs To replace storage drawer Removable Storage Drawer on some modelsRemovable Kick Panel on some models To remove storage drawerMetal Park CAW Am CLEAN~GOven Air Venk Surface Light and ShrterBroil and Bottom Burner Air Ad.iustment Shutters ~OR ADWST~NTS YOU can MA~To remove the oven bottom Read these instructions completely and carefilly MSTALLATION ~STRUCTIONSEyou smell gas LM~RTANT Safety Instructions General MSTALLATION mSTRUCTIONSConnect the Range to GAS PROVIDE ADEQuATE GAS SupplyConnect the Wnge to GM ~STALLATION ~STRUCTIONSRigid Pipe Hookup for Models Equipped with Sealed Burners IMPORT~-Please read careti~y GroundingElectrical Requirements Extension Cord CautionsElectric Disconnect ELECTRl~L ConnectionsSoft blue flame- Normal for natural gas Quali~ of Flames~STALLATION mSTRUC~ONS When ml Hookups are COMPLETE~ ~STALLA~ON ~STRUCTIONS HOW to Convert the Range for USE with 1P GAS or Natural GASIf range is equipped with dual burners Burnercap~ Orifice Spuds brConve~ingto U~STALLATION WSTRUC~ONS HOW to Convert the Range for USEBroil Burner on some models Oven Burner%fi blue fl=eb YeMow tips on outer conesYellow flames Yellow tips on outer Soft blue flame+ Oven WLL not WorkQUESTIONS? USE this Problem Solver Wdll Be There Warranty

JGBP26GEN, JGBP27GEN specifications

The GE JGBP27GEN and JGBP26GEN are two exceptional gas ranges that stand out in the market for their advanced features and user-friendly technologies. Both models cater to home chefs looking for precision in cooking, reliability, and a sturdy design that can withstand the rigors of daily use.

The GE JGBP27GEN features a spacious 5.0 cu. ft. oven capacity, providing ample room for large meals, whether it's a holiday feast or a weeknight dinner. This range is equipped with an extra-large oven window that allows users to monitor their cooking without opening the door, thus maintaining optimal temperatures. The oven also boasts a self-cleaning feature, utilizing high heat to eliminate food residue, making upkeep effortless for busy homeowners.

On the other hand, the JGBP26GEN presents a similar oven capacity but comes with a slightly more simplified design, yet it does not compromise on performance. Both models utilize a powerful 15,000 BTU burner, which ensures rapid heating and efficient cooking. With multiple burners ranging from simmer to high-heat settings, users have the flexibility to prepare a variety of dishes simultaneously.

A standout feature of both the JGBP27GEN and JGBP26GEN is their continuous grates, crafted from durable cast iron. These grates provide a stable cooking surface, allowing cookware to glide easily from burner to burner. This design is particularly advantageous for users who employ multiple pots and pans at once.

In terms of additional technologies, both models come equipped with a precise simmer burner that can maintain low temperatures ideal for delicate sauces and simmering tasks. The ranges also include an integrated electronic ignition system, which offers reliable and efficient ignition without the need for matches or lighters.

For aesthetics, both ranges are available in a classic stainless steel finish that adds a modern touch to any kitchen decor. The controls are conveniently located at the front, ensuring ease of use while cooking.

In summary, the GE JGBP27GEN and JGBP26GEN gas ranges combine modern functionality with user-oriented features, making them suitable choices for any cook. Their spacious ovens, powerful burners, and ease of maintenance speak to the needs of both novice cooks and seasoned chefs, making meal preparation enjoyable and efficient.
Top Page Image Contents