Unpacking the Cooker | HANDLING AND INSTALLATION INSTRUCTIONS |
|
|
HANDLING AND INSTALLATION INSTRUCTIONS
1.UNPACKING THE COOKER
Do not take any packaging off the cooker until it is directly in front of the place it is to be installed (unless it will not fit through a door in its outer packaging).
2.HANDLING INSTRUCTIONS
The following instructions are to be followed by qualified personnel, trained to handle extremely heavy loads. Usually, a
1.In order to lighten the cooker, remove and set aside the drawer, the backsplash, the handrail, the oven accessories, the pan supports and any other accessories.
2.Remove oven doors by engaging the latches on the hinges and by pulling the door back and up.
3.Create a harness with four Installer’s straps.
4.Twist the harness and tilt the cooker to place the harness.
5.When lifting up stairs, the straps of the handlers at the bottom should be shorter so the cooker stays level.
The back of the cooker should always face the inside of the ramp.
3.REMOVING AND REFITTING THE OVEN DOOR
Removing the Oven Door
Fig. 2
To remove the door, open the door fully. Swivel the locking ‘U’ clips forward to the locking position (Fig. 2). To remove the oven door, grip the sides of the door, lift upwards and then slide the door forwards (Fig. 3).
Fig. 3
Refitting the Oven Door
To refit the door, slide the hinges back into their slots. Rotate the locking ‘U’ clips back to fit onto the hinges.
18 | Installation and User Guide CornuFé 1908 - 36" - USA / Can |