CONNECTIONS | Gas connections |
|
|
Never use an old connector when installing a new range. If the hard piping method is used, you must carefully align the pipe; the range cannot be moved after the connection is made. To prevent gas leaks, put pipe joint compound on, or wrap pipe thread tape with Teflon* around, all male (external) pipe threads.
*Teflon: Registered trademark of DuPont
Install a manual gas line
Male threaded fitting, thread
1/2 NPT
Connect flexible metal appliance connector to the adapter on the range. Position range to permit connection at the
When all connections have been made, make sure all range controls are in the off position and turn on the main gas supply valve.
Use a liquid leak detector at all joints and connections to check for leaks in the system.
Use a product specifically manufactured for leak detection. Leak testing of the appliance shall be conducted in accordance to the manufacturer’s instructions.
The appliance must be connected to the type of gas shown on the rating plate of the
appliance.
The gas supply line must be at least a 1/2 inch pipe.
On all pipe joints use sealing compound that does not react to propane gas.
Check gas leaks by using a liquid leak detector.
Do not use an open flame
Note: Propane gas cylinders must never be located inside your home.
INSTALLER
Leave this manual with the appliance and advise
the customer to keep it for future reference. Inform the consumer of the location of the gas
Installation and User Guide CornuFé 1908 - 36" - USA / Can | 27 |