HANDLING AND INSTALLATION INSTRUCTIONS | Fitting the handrail |
|
|
4.FITTING THE HANDRAIL
The handrail is supplied as 2 end pieces with grub screws, 2 plastic friction cups and the rail tube (Fig. 4). Hold a friction cup by the tabs on one end of the tube. Fit one of the end pieces to the tube and push it on the tube over the friction cup (Fig. 5).
Turn the tube over and fit the other end piece using the second friction cup, making sure that you do not scratch or damage the first end piece and the that the two end pieces are lined up correctly.
Fit the assembled handrail to the projecting mounting studs on the control panel and fix it in place by tightening the grub screws. The grub screws should be on the underside.
5.RISER / BACKSPLASH INSTALLATION
Fig. 4
Fig. 5
Fig. 6 |
| Fig. 7 |
|
| |
Washer | |||||
|
|
|
| ||
|
|
|
|
|
Screw M5x16
Inserts
8 mm
The backsplash (flue grille) is packed separately (Fig. 7).
Use the screws and nuts supplied to fix the backsplash in place using an 8 mm wrench (not supplied) - Fig. 6.
6.GAS CHIMNEY PROTECTION INSTALLATION
Gas chimney protection plate comes separately in the package and needs to be installed above the flue channel behind the gas oven.
Gas oven chimney protection | 2 x Screw M5 x 16 mm + washer | Gas oven chimney protection |
| Installation and User Guide CornuFé 1908 - 36" - USA / Can | 19 |