ANTI-T~ DEVICE
efore placing range in the counter, notice the location of the stability bracket which is already a[tached to the back of the range. This location should work for most installations. However, it may he more convenient to hook the stability chain to the unit when the stability bracket is attached to the upper set O( holes in the back of the range. See Fig. A. The upper level set of holes are intended for Llse with a backsplash kit. If the backsplash is not being used, make sure that there are no structural supports for the countertop which will interfere with the stabilitv. bracket when located in the upper set of holes.
Q
Chain
Long ‘%Screw | Wall Plate |
\ | , |
W a s h e r \ \
\ , ~
h\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\~
3. | Temporarily attach the loose end of the chain |
| to the rear of the countertop with the tape from |
| the packaging. See Fig. D. |
4. | Place the range in the counter cutout leaving just |
| enough room between the back of the ran&e and the |
o
Bracket
Optional
Location
Bracket Factory Location ~
\.Backguard
“.. ‘ \
P
wall to reach the stability bracket. |
5. Hook the loose end of the chain onto the bracket by |
slipping the nearest link of the chain into the slot in |
the bracket. See Fig. A and make sure the chain is |
pulled as tight as possible and that there is no |
excess slack in the chain after the chain is attached |
to the bracket. |
CAUTION: Excessive slack in the chain A could allow the range to tip over.
II
| Mainback |
c | } |
|
2. Fasten one end of | o | Chain |
| |
the stabilitv chain to | \ | |||
| ||||
the tloor o; wall with |
|
|
| |
the long screw and | Washer and |
| ||
washer supplied. See |
| |||
ScreW |
| |||
Fig. B. Make certain |
|
|
| |
the screw is going |
| A | ||
4
into the wall-plat= at
the base of the wall or one of the studs in the base of the wall. See Fig. C. Whether you attach the chain to the wall or floor, be certain that the screw is in at least 3/4 inch thickness of wood other than baseboard and that there are no electrical wires or plumbing in the area which the screw could penetrate. Attach the stability chain in a location which will allow the chain to be in line with the bracket side to aide as much as possible when attached to the unit. Test to see if the chain is securely fastened by tugging on the chain.
6.Slide the range all the way back into the counter. Once the range is pushed back in place, there will be a small amount of slack in the chain. This
is normal.
-~-., Tape
NOTE:
●If attaching to masonry, you can buy suitable screws and anchors at hardware stores. Use a masonry drill to drill the required holes.
●If range is removed for cleaning or any other reason, make sure chain is reattached.
25