GE 164D2966P118 warranty Range Top Burners, To remove the burners, To replace the burners

Page 20

- -.,

CAm AND CLEANING

q;,,,...,,

M

 

Oven Shelves

Clean the shelves with a mild abrasive cleanser or steel wool. After cleaning, rinse the shelves with clean water and dry with a clean cloth.

Range Top Burners

The holes in the burners must be kept clean at all times for proper ignition and an even, unhampered flame.

You should clean the burners routinely, especially after bad spillovers which could clog these holes. Burners lift out for cleaning if the shipping screws were removed at installation.

NOTE: A screw holds each burner in place to keep them from wobbling around during shipment. Remove and discard the shipping screws. Be careful not to remove the screws from the igniter bracket.

sValve Orifice

To remove the burners:

1.Grasp the burner head and tilt it to [he right to release the two tabs from slots in the burner support.

2.Lift the end of the burner assembly, then pull away from the front of the range to free the air shutter from the gas valve orifice.

To remove burned-on food, soak the burners in a solution of mild liquid detergent and water. Soak the burners for 20 to 30 minutes. If the food doesn’t rinse off completely, scrub them with soap and water and a brush or plastic pad. Do not use steel wool or abrasive cleansers because they will clog the burner openings and scratch the burners. If the holes become clogged, clean them with a small sewing needle or a small safety pin.

Do not attempt to clean burners in an automatic dishwasher. Loosened food soil can clog burner holes, and the strong action of the dishwasher detergent can damage the burner heads.

Before putting the burners back, shake out excess water and dry them thoroughly by setting them in a warm oven for 30 minutes.

Ports

Lighter

F!as

support

Air Shu

To replace the burners:

1.Slip the air shutter over the gas valve orifice.

2.Lower the burner assembly and hook the tabs in the slots in the burner support.

3.Be sure both tabs are in their slots, that the burner sits level and straight, and that the flash tube forms a straight line from the igniter to the burner.

20

Image 20
Contents Gas Slide-in Range Save time and money. Before you request service Help US Help YOURead this guide carefully Write down the model and serial numbers~PORTANT Safety Instructions ~.YiPORTANT Safety NoticeWhen You Get Your Range Using Your RangeTo minimize the possibility of burns, ignition Wortant Safety InstructionsSurface CooKng Do not use aluminum foil anywhere in the oven ’ ..’Items Baking, Broiling and RoastingSave These Instructions FLOOmNG and LevelingFeatures of Your Range @ Q@HOW does this Cooktop Compare With Your OLD ONE? Suwace COO~NGElectric Ignition Surface Burner ControlsHow to Select Flame Size Light a Surface BurnerAfter Lighting a Burner Top-of-Range CookwareClock and Timer Using Your OvenVen Shelves Shelf PositionsOven Vent Ven LightHow to Set Your Range for Baking BakingOven Shelves Preheating Baking PansAn Placement Baking GuidesCookies CakesTo Adjust the Thermostat Bottom screW moes toward Aluminum FoilDont Peek ’’’!’Roasting Ye of Aluminum FoilQuestions and Answers Roasting GU~EFrozen Roasts MeatWhy are meats not turning out as brown as they should? BROIL~GTJse of Aluminum Foil Broiling TipsBROmING GU~E Beef SteaksCAm and Cleaning Control knobs may be removed for easier cleaningControl Panel and Knobs Brushed Chrome CooktopTo replace the burners Range Top BurnersTo remove the burners Lift-Off Oven Door Rner GratesDrip Pans Oven Light Bulb Broiler Pan and RackBroiler Drawer To removeMovable Oven Bottom Painted SurfacesTo replace the oven bottom Fit the front tabs into slots in front frameContinuous-Cleaning Oven Interior To Clean the Continuous-Cleaning OvenANTI-T~ Device Washer supplied. See ScreWYellow flames Yellow tips on inner USE this Problem SolverRA QUESTIONS? Wdll Be There Your GE GAS Range