INSTALLING THE BACKGUARD
The backguard must be installed prior to operation of the appliance for appropriate ventilation of the oven compartment.
The supplied backguard is a 2‐part assembly. The box also contains a set of metal screws for securing the backguard to the worktop.
Disassemble the backguard and position the front part on the worktop. Align the screw holes with the corresponding holes at the back of the worktop.
If the holes are not aligned, partially loosen the brackets att the back of the worktop as shown below.
Install the front part of the backguard by tightening the 2 central screws from the top and 2 lateral screws from the bottom.
Position the back part of the backguard and secure it to the worktop tightening 4 screws from the bottom.
Connect the back and front part of the upstand. Check for tight assembly.
9