Verona VEFSGG 244 warranty Burners and Grids, Correct Replacement of the SEMI-RAPID Burners

BURNERS AND GRIDS

✓These parts can be removed and cleaned with appropriate products.

✓After cleaning, the burners and their flame distributors must be well dried and correctly replaced.

✓It is very important to check that the burner flame distributor and the cap has been correctly positioned - failure to do so can cause serious problems.

✓Check that the probe next to each burner is always clean to ensure cor- rect operation of the safety valves.

✓Keep the electrode clean so that the sparks always strike.

✓Note: To avoid damage to the elec- tric ignition do not use it when the burners are not in place.

CORRECT REPLACEMENT OF THE SEMI-RAPID BURNERS

It is very important to check that the burner flame spreader “F” and the cap “C” have been correctly positioned (see figs. 5.1 and 5.2 ). 

Failure to do so can cause serious problems.

In appliances with electric ignition, check that the electrode “S” (figs. 5.1-5.3) is always clean to ensure trouble-free sparking.

Check that the probe “T” (figs. 5.1-5.3) next to each burner is always clean to ensure correct operation of the safety valves.

Both the probe and ignition plug must be very carefully cleaned.

CORRECT POSITION OF TRIPLE RING BURNERS

The triple ring burner must be correctly positioned (see fig. 5.3); the burner rib must be fitted in their housing as shown by the arrow.

The burner correctly positioned must not rotate (fig. 5.4).

Then position the cap A and the ring B (fig. 5.4 - 5.5).



C
F
	T
	S
Fig. 5.1	Fig. 5.2

T

S

Fig. 5.3

A B

Fig. 5.4 Fig. 5.5

19