Verona CTG212FD Operations to be Performed When Substituting the Injectors, Injectors Table

OPERATIONS TO BE PERFORMED WHEN SUBSTITUTING THE INJECTORS

✓Remove the gratings, the burner covers and the knobs;

✓Using a wrench substitute the nozzle injectors “J” (fig. 5.6) with those most suitable for the kind of gas for which it is to be used.

The burner are conceived in such a way so as not to require the regulation of the primary air.

J

Fig. 5.6

INJECTORS TABLE

	NOMINAL	REDUCED	LP/PROPANE		NATURAL GAS
	POWER	POWER	11” W.C.P.		4” W.C.P.
BURNERS	BTU/hr	BTU/hr	Ø injector	By-pass	Ø injector	By-pass
			[1/100 mm]	[1/100 mm]	[1/100 mm]	[1/100 mm]
Semi-rapid (SR)	6000	1500	72	34 (*)	118	adjustable
Rapid (R)	10000	2000	94	44 (*)	155	adjustable

(*) 34: brown coloured 44: green coloured

REGULATING THE BURNER MINIMUM SETTING

When switching from one type of gas to another, the minimum flow rate must also be correct: the flame should not go out even when passing suddenly from maximum to minimum flame.

To regulate the flame follow the instructions below:

–Light the burner

–Set the gas valve to minimum

On gas valves provided with adjustment screw in the centre of the shaft (fig. 5.7):

–Using a screwdriver with max. diameter 3 mm, turn the screw inside the tap until the correct setting is obtained.

For LP/PROPANE gas, tighten the adjustment screw completely.

After regulation repeat the operations indicated in paragraph “2. Pressure regulator” at page 12.

If the cooktop has been disconnected and then connected again to the gas supply line repeat the operations indicated in paragraph “5. Leak Testing” at page 16.

Fig. 5.7

17