Using Your Griddle, Before Using The First Time

USING YOUR GRIDDLE

BEFORE USING THE FIRST TIME:

1.Wash the griddle and the grease cup in warm, soapy water with a dishcloth or sponge to remove any manufacturing oils. Rinse thoroughly and dry. Be sure the socket is completely dry before inserting the temperature control. Slide the grease cup securely in place below the drain hole on the griddle surface. It is recommended that the grease cup be used with any cooking application to help contain possible overflows or spills.

2.Condition the non-stick finish by lightly wiping two teaspoons of cooking oil with paper toweling or a soft cloth over the entire cool surface. Let the cooking oil remain on the finish. Do not use butter or shortening to condition the non-stick surface.

3.Check to ensure the handles/legs are secured tightly to the griddle base. To tighten, place cool griddle upside down on the tabletop. Tighten the handle/leg screws by turning in a clockwise direction using a #2 Phillips screwdriver. Do not over tighten as stripping of the screws can occur. Periodic tightening may be required.

•A small amount of smoke and/or odor may occur upon heating due to the release of manufacturing oils – this is normal.

•Some minor expansion/contraction sounds may occur during heating and cooling – this is normal.

USING YOUR GRIDDLE

1.Always use on a dry, level, heat-resistant surface. Do not operate the griddle when hands are wet. Check to ensure the handles/legs are secured tightly to the griddle base. Attach the temperature control to the griddle with the dial set to the “OFF” position. Be sure the grease cup is securely in place below the drain hole on the griddle surface. Do not block airflow under the griddle. Plug cord into a 120 volt, AC electrical outlet ONLY.

2.Refer to the Temperature Guide in this booklet for selecting the correct heat settings. If food is taken directly from the freezer, use the heat setting as indicated in the guide, but allow a longer cooking time. Most foods require a preheat period.

3.The signal light on the temperature control will go out when the cooking temperature has been reached; add food. Heat may be increased or decreased, depending on personal preference and the type or amount of food being prepared. The signal light will go on and off periodically to indicate that proper temperature is being maintained.