Multiquip manual MVH-406DSY- Engine Components, MVH-406DSY Engine Components

MVH-406DSY— ENGINE COMPONENTS

Figure 5. MVH-406DSY Engine Components

ENGINE COMPONENTS

Figure 5 illustrates the location of the major lever components of the machine. Each component is described below:

1. Fuel Filler Cap – Remove this cap to add unleaded gasoline to the fuel tank.Make sure cap is tighten securely.

	DO NOT over fill.
2.	Fuel Tank – Capacity is 5.7 quarts (5.4 liters) of diesel
	fuel.
3.	Air Cleaner – Prevents dirt and other debris from entering
	the fuel system. Remove wing-nut on top of air filter
	cannister to gain access to filter element.
4.	Muffler – Used to reduce noise and emissions.

5. Recoil Starting Handle (pull rope) – Type of engine starting method. Alternate type would be electric start (ignition key).

6.Recoil Starter– Manual-starting method. Pull the starter grip until resistance is felt, then pull briskly and smoothly.

7.Oil Filler Cap / Dipstick – Remove this cap to add oil to the engine crankcase. Read dipstick to determine if oil level is low. DO NOT over fill.

8.Oil Drain Plug – Unscrew plug to drain oil from engine crankcase. Dispose of oil in a safe manner.

9.Decompression Lever– Press down before starting engine.To prevent damage to engine, DO NOT use for any other purpose.

10.Fuel Cock– Controls the flow of diesel fuel to the carburetor. Must be in the ON position when starting and running the engine.

MVH-406DSY PLATE COMPACTOR — OPERATION AND PARTS MANUAL — REV. #1 (08/13/07) — PAGE 15