Sharp r-8580 Signal to Sound, Signal svnchronized with commercial source frequencv50Hz, Heating

PIN NO.	1 29		1 SIGNAL	j	SI	E25	I	I/O
Used for initial		balancing of the bridge circuit(absolute				himidity sensor).
PIN NO.	/	30	1 SIGNAL	/	E26		I	I/O
Signal to	sound		buzzer.

A:Key touch sound.(O.l sec.)

B:Completion sound.(2.0 sec.)

C:When the temperature of the oven cavity reaches the preset temperature in the preheating hold time (15 minutes) is elapsed.

(I .O sec. ON-l .O sec. OFF repeat)

PIN NO. 1 31 SIGNAL j IRQ E27 I l/O

Signal svnchronized with commercial source frequencv(50Hz).

This is the basic timing for time processing of LSI.

PIN NO. 32 SIGNAL vss I I/O

Power source voltage: -5V.

VC voltage of power source circuit input.

R -8580

/ OUT

(RD936Al U)

/ OUT

preheating mode, or when the

(RD93LA2U)

/ IN

(RD93FEl U)

IN

(RD93GAl U)

PIN NO.	j 33	1 SIGNAL	/ RO	I	I/O	j OUT
Magnetron	high-voltaae	circuit driving	signal.

To turn on and off the cook relay.

In HIGH operation, the signals holds “L” level during microwave cooking and “H” level while not cooking. In other cooking modes (MED. HIGH, MED., MED. LOW, LOW) the signal turns to “H” level and “1” level in repetition according to the power level.

(RD933A2U)

PIN NO.	1 34	1 SiGNAL	( RI	I	I/O	j OUT
Oven lamp	and turntable	motor driving	siqnal.(Square	Waveform:fiOHz)

To turn on and off the control relay.

The pulse signal(50Hz) is delivered to the control relay driving circuit and cook relay, heater relay control circuit.

(RD932Fl U)

PIN NO.	35	SIGNAL / R2	I	l/O	j OUT
Heating	element	driving signal.

To turn on and off the heater relay.

“1” level during convection cooking; “H” level otherwise.

During convection cooking or mix cooking, the signal becomes “H” level when the temperature of the oven cavity exceeds the predetermined temperature.

(RD93464U)

PIN NO. j 36 1 SIGNAL / R3 I I/O j OUT

Coolinrr fan motor driving signal.

To turn on and off the cooling fan motor relay, “1” level during both microwave and convection cooking; “H” level otherwise.

fRD934B2Ul

PIN NO.	1 37	1 SIGNAL	j R4	I	I/O	j OUT
Convection	motor driving	sianal.

To turn on and off the convection motor. “1” level during CONVECTION or MIX COOK; “H” level otherwise.

(RD93468U)

25