Step 5 Release all buttons.
AUS
OTHER NOTES ON TIMER OPERATION
1. When cooking Automatically the Cook Period can |
A | . 2 0 |
OT1 4 | |
U |
|
|
|
NOTE: The Cookpot symbol disappears
A | . 2 0 |
OT1 6 | |
U |
|
The timer display will revert to the time of day with the 'Auto' symbol lit & 'cookpot' symbol remaining lit.
At the end of the Cook Period the 'Auto' symbol will flash and an intermittent audible tone will be heard.
The audible tone will continue until cancelled. The 'Auto' symbol will continue to flash until the timer is returned to Manual operation (see below).
| be checked at any time simply by pressing the |
| Cook Period button. |
2. | When cooking Automatically the End Time can be |
| checked at any time by simply pressing the End |
| Time button. |
3. | Having set a Cook Period and End Time an |
| electronic device stores the information. The device |
| within the timer will switch the oven(s) on and off at |
| the required times. |
4. | When setting an Auto Cooking Programme and a |
| mistake is made, to clear:- |
| (a) Press & release the Manual button. |
| (b) Start the sequence again. |
5. | If at any time the display shows three flashing zero's |
| 0.00 and 'Auto', it is likely that the electricity supply |
| to the oven has been interrupted. Reset the timer |
| to the correct time of day. Food in the oven may, |
1 6 | . 2 0 | Step 6 Press the Manual | |
button. The audible tone will be | |||
|
| ||
|
| cancelled and the oven(s) will be | |
|
| returned to Manual. |
Step 7 Turn the oven control(s) to the OFF position.
TO CANCEL AN AUTO COOKING PROGRAMME BEFORE THE COOK PERIOD HAS FINISHED.
Step 1 Turn the oven control to the OFF position.
1 5 . 0 0
Step 2 Press the Manual button to return the oven to "Manual" operation. The 'Auto' symbol will go out.
Note 1 When cooking automatically the Cook Period can be checked at any time by simply pressing the Cook Period button.
therefore, not have been cooked, before serving |
check food is thoroughly heated and completely |
cooked. |
6. To set each function always press and hold the |
required function button and at the same time press |
"+" or |
8