Sharp R-1500, R-1505, R-1501, R-1506 service manual KEY Unit Test

Page 20
KEY UNIT
18

R-1500

R-1501

R-1505

R-1506

TEST PROCEDURES

PROCEDURE

LETTER

COMPONENT TEST

8)Run the oven and check all functions.

2.Control Unit.

The following symptoms indicate a defective control unit. Before replacing the control unit, perform the Key unit test (Procedure M) to determine if control unit is faulty.

2-1 In connection with pads.

a)When touching the pads, a certain group of pads do not produce a signal.

b)When touching the pads, no pads produce a signal.

2-2 In connection with indicators

a)At a certain digit, all or some segments do not light up.

b)At a certain digit, brightness is low.

c)Only one indicator does not light.

d)The corresponding segments of all digits do not light up; or they continue to light up.

e)Wrong figure appears.

f)A certain group of indicators do not light up.

g)The figure of all digits flicker.

2-3 Other possible problems caused by defective control unit.

a)Buzzer does not sound or continues to sound.

b)Clock does not operate properly.

c)Cooking is not possible.

When testing is completed,

1)Disconnect the power supply cord.

2)Open the door and block it open.

3)To discharge high voltage capacitor, wait for 60 seconds.

4)Reconnect all leads removed from components during testing.

5)Re-install the hood intake duct R.

6)Re-install the outer case (cabinet).

7)Reconnect the power supply cord after the outer case is installed.

8)Run the oven and check all functions.

MKEY UNIT TEST

1.Disconnect the power supply cord.

2.Open the door and block it open.

3.To discharge high voltage capacitor, wait for 60 seconds.

4.Remove the control panel assembly.

5.If the display fails to clear when the STOP/CLEAR pad is depressed, first verify the flat ribbon cable is making good contact, verify that the door sensing switch (stop switch) operates properly; that is the contacts are closed when the door is closed and open when the door is open. If the door sensing switch (stop switch) is good, disconnect the flat ribbon cable that connects the key unit to the control unit and make sure the door sensing switch is closed (either close the door or short the door sensing switch connecter). Use the Key unit matrix indicated on the control panel schematic and place a jumper wire between the pins that correspond to the STOP/CLEAR pad making momentary contact. If the control unit responds by clearing with a beep the key unit is faulty and must be replaced. If the control unit does not respond, it is faulty and must be replaced. If a specific pad does not respond, the above method may be used (after clearing the control unit) to determine if the control unit or key pad is at fault.

6.

Reconnect

all

leads

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

G 8

 

 

 

G 7

 

 

G 6

 

 

G 5

 

 

G 4

 

 

G 3

 

 

G 2

 

 

 

G 1

 

 

 

removed from components

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

during testing.

 

9

 

POPCORN

 

REHEAT

2

 

 

RICE

FRESH

 

HOT

3

 

 

LIGHT

 

 

G

 

 

CENTER

 

 

VEGETABLES

WATER

 

 

HI / LO

7.

Re-install the control panel

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

assembly.

 

 

G10

 

KEEP

 

GROUND

4

 

GROUND

FROZEN

5

 

6

 

 

 

FAN

 

 

 

 

 

 

MEAT

 

 

MEAT

 

 

 

 

 

 

 

 

WARM

 

 

 

 

ENTREES

 

 

 

HI / LO

 

 

 

 

(DEFROST CENTER)

 

 

 

 

(COOK CENTER)

 

 

 

 

 

 

 

 

 

8.

Reconnect

the

power

 

 

 

 

 

 

 

POULTRY

 

 

 

 

FROZEN

STEAKS /

 

 

 

 

 

 

 

 

 

STOP

G11

 

 

 

 

 

7

 

8

 

9

 

 

supply cord.

 

 

 

 

 

 

 

BONELESS

 

VEGETABLES

CHOPS

 

 

 

CLEAR

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

START

9.

Run the oven and check all

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

G12

 

 

 

 

 

1

 

POWER

BAKED

POULTRY

0

 

TIMER

MINUTE

 

 

 

 

 

 

LEVEL

POTATOES

BONE-IN

 

CLOCK

 

functions.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

PLUS

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Page 19 Page 21
Image 20
Page 19 Page 21
Contents Table of Contents 1506Before Servicing When the testing is completed Dont Touch Before ServicingLeakage test Microwave Measurement ProcedureRequirements Sharp PLAZA, Mahwah Over the Range Microwave Oven1500/ R-1501/ R-1505/ R-1506 ForewordProduct Specification General InformationDescription Grounding InstructionsOven Diagram Light HI/ LO FAN HI/ LO Stop Clear Start Minute Plus Control PanelLevel Power Level P-0 to P-90 Cooking OperationDescription of Operating Sequence OFF ConditionVentilation Methods HOT AIR Exhaust Vertical VentingAIR Flow Horizontal VentingFigure O-1. Oven Schematic-Off Condition Description and Function of Components Hood Lamp Troubleshooting GuideHood FAN Motor Test Procedure Problem Possible Case Defective PartsTest Procedures Procedure Letter Component Test Magnetron Assembly TestMicrowave Output Power Power Transformer TestProcedure Letter Component Test Magnetron Temperature Fuse TestHigh Voltage Rectifier Test High Voltage Capacitor TestPrimary Interlock Switch Test Secondary Interlock System Test Door Sensing SwitchMonitor Switch Test Secondary Interlock Relay RY2Procedure Component Test Letter Blown Monitor Fuse TestHood Thermal CUT-OUT Test Hood FAN Motor TestWHT 3 Touch Control Panel Assembly TestBefore testing KEY Unit Test Procedure Letter Component Test Relay Test Foil Pattern on the Printed Wiring Board TestDefrost Center Test 1ST Stage 2ND StageQKITPB035 Steps Occurrence Cause or CorrectionLSI Touch Control Panel AssemblyDescription of LSI OUT Oven lamp, fan motor and turntable motor driving signal Signal synchronized with commercial power source frequencyInternal clock oscillation frequency input setting OUT Key strobe signalKey strobe signal Hood lamp driving signalHood motor high / low driving signal Hood motor driving signalOther Precautions ServicingShapes of Electronic Components Servicing of Touch Control PanelComponent Replacement and Adjustment Procedure Hood Exhaust Louver RemovalPower Transformer Removal Re-installPictorial Diagram Outer Case RemovalMagnetron Removal High Voltage Rectifier and High Voltage Capacitor RemovalHood FAN Thermal CUT-OUT Removal Thermal CUT-OUT Cavity RemovalTemperature Fuse Magnetron Removal Cooling FAN Motor RemovalPositive Lock Connector NO-CASE Type Removal Control Panel ASSEMBLY, Control Unit and KEY Unit RemovalPositive lock connector Turntable Motor and Food Lamp Sockets RemovalKey unit location Control Unit and KEY Unit RemovalDoor Replacement After adjustment, check the followingDoor Assembly Removal Door Assembly RE-INSTALLDoor Disassembly ReplacementDoor Frame Assembly Choke CoverControl Unit High Voltage ComponentsFigure S-2. Power Unit Circuit Circuit UnitDIP Parts List Parts marked * are used in voltage more thanElectric Parts Cabinet PartsMiscellaneous Oven PartsDoor Parts HOW to Order Replacement Parts Packing and AccessoriesSCREWS,NUTS and Washers Model NumberOven and Cabinet Parts Control Panel Parts Door Parts Miscellaneous Copyright 2001 by Sharp Corporation ALL Rights Reserved
Related manuals
Manual 40 pages 37.06 Kb

R-1506, R-1501, R-1505, R-1500 specifications

The Sharp R-1500, R-1505, R-1501, and R-1506 are part of Sharp's extensive line of microwave ovens, showcasing advanced cooking technologies and user-friendly features that cater to the modern kitchen. These models are designed to provide convenience and efficiency while delivering consistent cooking results.

One of the standout features across these models is the use of Sharp's innovative microwave technology, which ensures even heating and cooking. This is achieved through a combination of advanced microwave distribution systems that help to minimize cold spots common in traditional microwaves. As a result, users can enjoy perfectly cooked meals, whether it's reheating leftovers or preparing a fresh dish.

Each model comes equipped with a variety of cooking presets that simplify meal preparation. These presets are tailored for a range of foods, including popcorn, pizza, vegetables, and baked goods. With just the press of a button, users can automatically adjust the cooking time and power level, making the cooking process intuitive and hassle-free.

The R-1500 and R-1505 models, in particular, offer a sleek and modern design that can seamlessly blend into any kitchen décor. The front-facing control panel is easy to read and navigate, while the spacious interior can accommodate larger dishes, making these models ideal for family meals or entertaining guests.

In addition to their cooking capabilities, these microwaves prioritize energy efficiency and safety. With features like a child lock function and an eco-mode, users can have peace of mind knowing that their appliance is safe for the entire family and environmentally conscious.

The R-1501 model adds additional versatility by including a grill function, allowing users to achieve that perfect crispiness on meats and vegetables. This feature enhances the range of cooking options available, making it suitable for those who enjoy grilling but may not have the outdoor space or equipment.

Lastly, the R-1506 combines the benefits of microwave cooking with user-friendly features such as a digital display and programmable timers. This model is particularly well-suited for busy households, as it allows for quick meal prep without sacrificing quality.

In summary, the Sharp R-1500, R-1505, R-1501, and R-1506 microwave ovens represent a blend of advanced technology, safety features, and user-convenience. They cater to a broad spectrum of cooking needs, from basic reheating to more complex meal preparations, all while maintaining a focus on efficiency and style.
Top Page Image Contents