Sensor Data Transmission, Clock and Calendar

SENSOR DATA TRANSMISSION

Data is sent from the sensor(s) every 60 seconds. The reception icon shown in the Temperature / Humidity Area indicates the status.

ICON					DESCRIPTION

					Main unit is searching
					for sensors.
					for sensors.

					At least 1 channel has
					been found.
					been found.

					Sensor 1 is sending
					data. (The number
					shows which sensor is
					selected.)

--- shows in Temp /					The selected sensor
Humidity Area					cannot be found.
					Search for the sensor
					or check batteries.

Then, press and hold MEM and CH for 2 seconds.

NOTE If the sensor is still not found, check the batteries.

CLOCK AND CALENDAR

This product tracks the time and date based on radio- controlled signals from the RTGR328N remote sensor, or manual settings that you enter.

1
2	3
	3

1.RF Clock time

2.World Time city

3.World Time clock

SEARCH FOR SENSOR

To search for a Thermo / Hygro sensor, press SEL to navigate to the Temperature / Humidity Area. will show next to the Area. Then, simultaneously press and hold MEM and CH for 2 seconds.

To search for the UV sensor, press SEL to navigate to

the UVI / Barometer Area.

will show next to the Area.

RADIO-CONTROLLED CLOCK

The time and date are automatically updated by radio- controlled clock signals from official time-keeping organizations in Frankfurt (Germany) and Rugby (England) unless you disable this feature. The signals are collected by the remote sensor (RTGR328N) whenever it is within 1500 km (932 miles) of a signal.

Initial reception takes 2-10 minutes, and is initiated when

BAR916HG_EN_OP.indd 12

5/8/06 11:23:27 AM