Moyer Diebel 501-HTN, 501-LT technical manual Standard equipment includes, Model Numbers, Options

Page 9

GENERAL

GENERAL

This manual covers the Moyer Diebel undercounter dishwashing machine. This machine is fully automatic and is equipped with a 1/2 H.P. pump motor. All models are available for mounting directly to the floor or on optional stands (see accessories listed on page 4).

Standard equipment includes:

 

-Automatic tank fill

-Upper and lower wash/rinse arms

-Common utility connections

-Two dish racks (peg and flat)

-120 Volt control circuit

-Exclusive vent design for

-Convenient, easy to use controls

venting of condensation

-Door latch activated start switch

-Stainless steel heavy-gauge construction,

-Detergent pump

including base

-Final Rinse Sentry (high temp models only)

This series of dishwashers is available in the following models:

Model Numbers

501HT, 501HTN, 501LT

•The 501HT model is a high temperature (82oC/180oF rinse) sanitizing model with booster.

•The 501HTN model is a high temperature (82oC/180oF rinse) sanitizing model without booster.

•The 501LT model is a low temperature (60oC/140oF rinse) sanitizing model for use with 5.25% or 8.4% sodium hypochlorite solution (chlorine bleach) as a sanitizing agent. The rinse aid pump is optional.

Options

•Kit 504 - Top and side panels (P/N 0708756)

•Kit 505 - Top panel only (P/N 0708744)

•Kit 506 - Left side panel only (P/N 0708745)

•Kit 507 - Right side panel only (P/N 0708746)

•Kit 508 - Rinse aid pump kit (P/N 0708754)

•Kit 510 - Extended reach pumped drain kit (HT, HTN, LT) (P/N 0708766)

•Kit 511 - 30oC/70oF temperature rise booster (for 49oC/11OoF supply water).

3

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Technical Manual Moyer Diebel Limited Moyer Diebel, US Revision History This Intentionally Left Blank Contents Detergent Pump Assembly Welcome to Moyer Diebel IntroductionLimited Warranty Standard equipment includes Model NumbersOptions Accessories Electrical Power RequirementsWire Plus Ground Diagram Electrical Connections UnpackingDetergent Plumbing ConnectionsRinse Aid Chemical SanitizerCompleting Installation Operation Procedures Operation Summary501LT 60C/140F To use the Extended Wash Cycle Extended Wash CycleCleaning Schedule Daily-Every 8 HoursMeal Periods Deliming Process DelimingMaintenance Schedule As RequiredWeekly Condition Cause Solution TroubleshootingTroubleshooting con’t Replacement Parts Track and Panel Assembly Part Description Qty Item No TRACK/PANEL AssemblyDoor Switch Assembly Door & Switch Assembly Tank Heat and Drain Part Description Tank HEAT/DRAIN AssemblyPump Assembly Pump Assembly Wash System Assembly Wash System Assembly 715 Water Inlet Piping Assembly Fill System All Models Part Description Fill SystemBooster Assembly Includes Models HT, UT, UT-LC Part Description Booster AssemblyDetergent Pump Assembly Detergent Pump Assembly Detergent To Fill Pump see FIG System To Chemical Supply SANITIZER/RINSE AID Pump LT/UTL Drain Pump Assembly 501 UTL, UT-LC Part Description Drain Pump AssemblyControl Cabinet Control Cabinet Assembly HT, HTN, LT, UTL, UT, UT-LC Control Cabinet Assembly cont’d Electrical Schematics Electrical Schematics Electrical Diagram, 501-HT For machines Ranging from S/N Electrical Diagram, 501-HTN For machines beginning with S/N Electrical Diagram, 501-LT For machines beginning with S/N Electrical Diagram, 501-HT 50 Hz To Customer Disconnect Switch 115V Neutral Electrical Diagram, 501-HTN For machines built prior to S/N CLT If Used Timer Assembly 501HT Timer Assembly 501HT Timer Assembly 501UT Timer Assembly 501LT
Top Page Image Contents