Moyer Diebel 301HT M2 installation manual Electrical Connections

Page 11

Installation

Electrical Connections

Note:

Leave enough electrical cable behind the machine so that the dishwasher can be pulled forward a minimum of two feet to be serviced.

Warning:

Electrical and grounding connections must comply with all local electrical codes or in the absence of local codes then connections must comply with the National Electrical Code.

Warning: When working on the dishwasher, disconnect the main electric service and tag it to indicate work is being done on that circuit.

1.The electrician should compare the electrical specifications on the machine electrical data plate (located in the control panel) to the electrical power supply before connecting the machine to the incoming service at a fused disconnect switch.

IMPORTANT: The 208-240V/60Hz/1PH electrical supply service for this machine must be a 2-wire plus ground service. For optional 208-240V/60Hz/3PH the electrical supply service must be a 3-wire plus ground service.

2.On the 208V-240V models, a knockout is provided at the rear of the junction box for electrical service connections. A fused disconnect switch or circuit breaker (supplied by user) is required to protect each power supply circuit.

Refer to the MACHINE ELECTRICAL CONNECTION DATA PLATE for the dishwasher power requirements.

3

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Installation Manual with Service Replacement Parts National Service Department Business Reply Mail Important Important Revision History Limited Warranty Table of Contents Model Descriptions Receiving Receiving Electrical Connections Water Connections Plumbing ConnectionsChemical Dispensers Initial Start-up Initial Start UpInitial Start Up Operation Operation ProceduresAfter Meal Periods or 8 Hours of Operation CleaningDe-liming De-liming ProcedureMaintenance Condition Cause Solution TroubleshootingClean with paper clip/delime This Intentionally Left Blank Service Replacement Parts Hood and Tank Assembly Item No Description Qty Unit Door Assembly Door Weldment Does not include hardware Wash Tank Heater and Chemical Dispensers Squeeze Tube, Detergent comes with black fittings Fill Piping Assembly Fill Piping Assembly Drain Assembly Drain Assembly Wash and Rinse Piping Assembly Hardware for Mounting Pump Wash and Rinse Arm Assemblies Wash and Rinse Arm Assemblies Wash Pump/Motor Assembly Wash Pump/Motor Assembly Booster Heater Assembly Booster Heater Assembly Control Panel Assembly Be sure to order Item Control Cabinet Assembly Control Cabinet Assembly This Intentionally Left blank Electrical Schematic and Timing Chart Electrical Schematic Timing Chart
Top Page Image Contents