De-liming Procedure

Cleaning

De-liming

Danger:

Death or serious injury may result when de-liming solution is mixed with sodium hypochlorite (chlorine bleach) sanitizing agent. Mixing may cause hazardous gases to form.

De-liming solution and other acids must never be mixed with chlorine, iodine, bromine, or fluorine.

Caution:

Skin contact with de-liming solutions can cause severe irritation and possible chemical burns. Always wear protective clothing when handling chemicals.

Attention:

Contact your chemical supplier for specific safety procedures and instructions for the use of the de-liming solution supplied for the dishwasher.

De-liming solution or other chemicals are not supplied by the dishwasher manufacturer.

1.Remove the chemical pick-up tubes from their supply containers.

2.Place the pick-up tubes in a container of warm water.

3.Push each prime switch to flush remaining chemicals out of the chemical tubing.

3.Close the door fully.

4.Press the POWER switch to fill the machine.

5.Open the door and add de-liming chemical into the wash tank compartment.

6.Close the door fully, then press the START switch to begin a cycle.

7.Run 3 complete cycles, then press the POWER switch to the OFF position.

8.Open the door and remove the drain/overflow tube from the wash tank.

9.Close the door.

10.Press and Hold the DRAIN switch to drain the machine.

11.Replace the drain/overflow tube, then close the door.

12.Re-insert the chemical pick-up tubes in the proper containers and prime the chemical dispensing pumps.

13.De-liming is complete.