Moyer Diebel 301HT M2 installation manual Chemical Dispensers

Page 13

Installation

Chemical Dispensers

ATTENTION:

Chemical dispensers must be electrically grounded in compliance with applicable electric codes.

adapter (supplied by others). Do not connect drain hose to a 90° drain fitting.

Detergent

The machine is equipped with an automatic detergent dispensing pump system.

1.Use a qualified detergent/chemical supplier for your detergent.

2.Your machine is supplied with a detergent dispensing pump that is internally wired and ready for use. Use a commercial grade liquid detergent and insert the red pickup tube into the detergent container. The pickup tube has a strainer on the end to prevent the crystallized chemical from clogging the supply lines.

Always wash hands under running water if they come into contact with the detergent and comply with the instructions pertaining to the specific type of detergent.

To prime the peristaltic pump:

1.Insert pick-up tube into the detergent container.

2.Close machine door and switch machine on.

3.Push and hold the prime switch.

Rinse Aid

1.Use a qualified/chemical supplier for your rinse aid needs.

2.Insert the transparent tube into the container containing the rinsing agent.

3.Push and hold the prime switch

Completing the Installation

1.Remove any foreign materials from inside the machine.

2.Install the scrap screens, wash and rinse arms, strainer basket and overflow tube.

3.After plumbing and electrical connections are completed, check machine for water leaks by closing the door, then depressing the ON switch. This allows the tank to begin filling and to reach temperature.

4.Open the door and check the water level. The water level should be 2 inches above the scrap screen.

5. Close the door fully.

Caution:

 

Connecting chemical dispensers at points other than those recommended by the factory may damage the dishwasher electrical system. Damage caused by the installation of chemical equipment will not be covered the WARRANTY.

5

Image 13
Contents Installation Manual with Service Replacement Parts National Service Department Business Reply Mail Important Important Revision History Limited Warranty Table of Contents Model Descriptions Receiving Receiving Electrical Connections Water Connections Plumbing ConnectionsChemical Dispensers Initial Start-up Initial Start UpInitial Start Up Operation Operation ProceduresAfter Meal Periods or 8 Hours of Operation CleaningDe-liming De-liming ProcedureMaintenance Condition Cause Solution TroubleshootingClean with paper clip/delime This Intentionally Left Blank Service Replacement Parts Hood and Tank Assembly Item No Description Qty Unit Door Assembly Door Weldment Does not include hardware Wash Tank Heater and Chemical Dispensers Squeeze Tube, Detergent comes with black fittings Fill Piping Assembly Fill Piping Assembly Drain Assembly Drain Assembly Wash and Rinse Piping Assembly Hardware for Mounting Pump Wash and Rinse Arm Assemblies Wash and Rinse Arm Assemblies Wash Pump/Motor Assembly Wash Pump/Motor Assembly Booster Heater Assembly Booster Heater Assembly Control Panel Assembly Be sure to order Item Control Cabinet Assembly Control Cabinet Assembly This Intentionally Left blank Electrical Schematic and Timing Chart Electrical Schematic Timing Chart