Bretford FP42ULC manual Jj Kk, Step

Page 7

STEP 8

Push a caster into each leg insert. To ensure casters are securely in place, a rubber mallet may be used to tap them in place. NOTE: The locking casters MUST be installed on the same side as the handle.

STEP 9

Attach the monitor bracket onto the front of the rear leg tubes as shown using bolts (JJ) and nuts (KK).

JJ

Image 7

Contents FLAT PANEL CABINET CART WITH OR WITHOUT A PULL OUT SHELF PARTS LISTHARDWARE LIST FP42ULC FP42MULCAA BB STEPBRACKET TO THE INSIDE Slide on middle shelf Slide on bottom shelf Slide on front legs AA BB INSTALL HARDWARE TO TOP SHELF CORNER ONLY, OMIT HANDLE SIDE AA BBSecure tube and top shelf together using screws HH and nuts HH Install handle to either side of the cart using bolts GG and nuts BBNOW TIGHTEN ALL CART CORNER HARDWARE Side Panel AA BB INSTALL HARDWARE TO EACH CORNER AA BB Rear PanelInstall door stop to bottom shelf using screws CC and nuts DD JJ KK CUTOUT A CUTOUT B SKIP TO STEP 15 IF YOUR CART DOES NOT HAVE A SHELF STEPExtend the slides to the positioning shown TAB TAB CUTOUTTOP BOTTOM CENTER MONITOR HORIZONTALLY THEN SECURE driver bit provided LL031-8691 Rev. 05.11.11 CZ