Bretford FP42ULC manual Skip To If Your Cart Does Not Have A Shelf Step, Cutout A Cutout B

Page 8
SKIP TO STEP 15 IF YOUR CART DOES NOT HAVE A SHELF

SKIP TO STEP 15 IF YOUR CART DOES NOT HAVE A SHELF

STEP 10

Attach each shelf bracket under the top shelf as shown using screws (FF).

Make sure the bracket cutouts face this way, if not the bracket will be installed upside down.

FF

STEP 11

Install the outer slide onto the shelf bracket by sliding TAB 1 into CUTOUT A and TAB 2 into CUTOUT B.

The pull out shelf should be installed opposite of the handle.

TAB 1

TAB 2

 

CUTOUT ACUTOUT A CUTOUT B CUTOUT B Manual background

This tab determines where the shelf will slide out from.

Each cart bracket has additional cutouts to allow the shelf to pull out from either side of the cart.

NOTE: Some bend in the bracket is ok as the slides and shelf will take care of that once

they are installed.

8

Image 8
Contents PARTS LIST HARDWARE LISTFP42ULC FP42MULC FLAT PANEL CABINET CART WITH OR WITHOUT A PULL OUT SHELFBRACKET TO THE INSIDE STEPAA BB INSTALL HARDWARE TO TOP SHELF CORNER ONLY, OMIT HANDLE SIDE AA BB Slide on middle shelf Slide on bottom shelf Slide on front legs AA BBInstall handle to either side of the cart using bolts GG and nuts BB Secure tube and top shelf together using screws HH and nuts HHSide Panel AA BB INSTALL HARDWARE TO EACH CORNER AA BB Rear Panel NOW TIGHTEN ALL CART CORNER HARDWAREInstall door stop to bottom shelf using screws CC and nuts DD JJ KK SKIP TO STEP 15 IF YOUR CART DOES NOT HAVE A SHELF STEP CUTOUT A CUTOUT BExtend the slides to the positioning shown CUTOUT TAB TABTOP BOTTOM 031-8691 Rev. 05.11.11 CZ driver bit provided LLCENTER MONITOR HORIZONTALLY THEN SECURE