Belt adjustments
NEVER move the base for motor (R)(in the oblong holes) , this is a factory setting and is NOT used to tighten the belts.If the entire unit is to be exchanged, reference the below table.
Models
1. Start by tightening the
1.A) Loosen the bolts (D) and the jam nut (E).
1.B) Tighten the bolt (F) until the
........tighten the the 2 bolts (D).
...C) Back bolt (F) out away from arm. DO NOT
........LEAVE AGAINST ARM.
2.If the main vari belt (A) appears loose when the
....unit is running.
...A) Remove nut (J) and washers (H).
...B) Pry upper spring fork assembly (N) off of shaft.
...C) Remove 1 or 2 washers from (G).
...D) Reinstall spring fork assembly (N) , washers
.......(H) and nut. (J). DO NOT TIGHTEN NUT.
...E) Start the mixer and tighten nut (J) until snug.
3.Now turn to Page 20 and follow the instructions
...“Adjustment of low (min) and high (max) speed ..
....microswitches”.
17