Roland S-OPT owner manual Installing the Ferrite Core on Ethernet Cables

Notes to Observe in Using the REAC System

Installing the Ferrite Core on Ethernet Cables

For REAC connections, make sure to attach ferrite cores to your cables.

If you want to use REAC cable SC-W100S (sold separately) or Cat5e cable instead of the included REAC cable with the S-OPT, please remove the Ferrite Core from the included REAC cable, then install the ferrite core on the SC- 100S or the Cat5e cable near the RJ45 plug that will be connected to the REAC port.

Use the following procedure to install a ferrite core on an Ethernet cable.

1.Lift up the ferrite core’s tabs and open the ferrite core.

2.Place the REAC cable SC-W100S or Ethernet cable in the ferrite core so that the core abuts the base of the cable’s connector.

3.Push the tabs until they close securely with a snapping sound.

13