Always unplug from outlet when not, Appliance

Important

Safeguards

When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock and/or injury to persons, including the following:

1.	READ ALL INSTRUCTIONS.
2.	Always unplug from outlet when not
	in use and before cleaning. Allow to
	cool before putting on or taking off
	parts and before cleaning the
	appliance.
3.	Do not touch hot surfaces. Use handles
	and knobs.
4.	To protect against electric shock and

cord into the wall outlet. To disconnect, turn controls to Off, then remove plug from wall outlet.

12.	Scalding may occur if the water filter
	compartment cover is removed during
	the brewing cycles.
13.	Do not use appliance for other than
	intended use.
14.	Do not lift handle to open the lid of the
	brewer while brewing is in progress.
15.	Do not overfill the water reservoir with
	water. Use only water in this
	appliance! Do not put any other liquids
	or foods in the water reservoir except
	as instructed in the cleaning instructions
	in this guide.
16.	Do not clean drip tray with cleansers,
	steel wool pads, or other abrasive

SPECIAL CORD SET

INSTRUCTIONS

A short power-supply cord is provided to reduce the risks resulting from becoming entangled in or tripping over a longer cord.

Longer extension cords are available and may be used if care is exercised in their use.

If a long extension cord is used, the marked electrical rating of the extension cord must be at least as great as the electrical rating of the appliance. The extension cord should be a grounding-type 3-wire cord, and the longer cord should be arranged so that it will not drape over the countertop or tabletop where it can be pulled on by children or tripped over.

If a grounding-type outlet is not available, an adapter, shown in Figure B, may be obtained so that a 2-slot wall outlet can be used with a 3-prong plug. As shown in Figure C, the adapter must be grounded by attaching its grounding lug under the screw of the outlet cover plate.

NOTE: Do not remove the grounding prong.

CAUTION: Before using an adapter, it must be determined that the outlet cover plate screw is properly grounded. If in doubt, consult a licensed electrician. Never use an adapter unless you are sure it is properly grounded.

Note: Use of an adapter is not permitted in Canada.

	injury to persons, do not place cord,
	plug, or base unit in water or other
	liquids.
5.	Close supervision is necessary when
	any appliance is used by or near
	children.
6.	Do not operate any appliance with
	a damaged cord or plug or after the
	appliance malfunctions or has been
	dropped or damaged in any manner.
	Return appliance to the nearest
	Cuisinart Repair Centre for examination,
	repair, or electrical or mechanical
	adjustment.
7.	The use of accessory attachments not
	recommended by Cuisinart may cause
	injuries, fire, electric shock or injury to
	persons.
8.	Do not use outdoors.
9.	Do not let cord hang over edge of table
	or counter, or touch hot surfaces.

materials.

17. WARNING: TO REDUCE THE RISK OF

FIRE OR ELECTRIC SHOCK, DO NOT

REMOVE THE BASE PANEL. NO

USER-SERVICEABLE PARTS ARE

INSIDE. REPAIR SHOULD BE DONE

ONLY BY AUTHORIZED PERSONNEL.

18. Do not operate your appliance in an

appliance garage or under a wall cabi-

net. When storing in an appliance

garage, always unplug the unit from

the electrical outlet. Not doing so

could create a risk of fire, especially if

the appliance touches the walls of the

garage or the door touches the unit as

it closes.

SAVE THESE

INSTRUCTIONS

NOTICE

If you have a diecast metal unit, for your protection it is equipped with a 3-conductor cord set that has

a molded 3-prong grounding-type plug, and should be used in combi- nation with a prop- erly connected grounding-type outlet as shown in Figure A.

Circuit Grounding

Conductor

Connected

Properly

Grounding

Prong

Adapter Grounding Lug

Cover

Mounting

Screw

Cover of

Grounded

Outlet Box

IMPORTANT UNPACKING INSTRUCTIONS

1.Place the box on a large, sturdy, flat surface.

2.Remove the instruction book and any other literature.

3.Turn the box so that the back side of the brewer is down and slide the coffeemaker from the box.

4.After removing the brewer, place the box out of the way and take the side pulp molded inserts away.

5.Remove the polybag covering the brewer.

We suggest you save all packing materials in the event that future shipping of the machine is needed. Keep all plastic bags away from children.

10.	Do not place on or near a hot gas or
	electric burner, or in a heated oven.
11.	Always fill water reservoir first, then plug

FOR HOUSEHOLD USE ONLY

WARNING

WARNING: RISK Of FIRE OR ELECTRIC SHOCK

The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous voltage within the product’s enclosure that may be of sufficient magnitude to constitute a risk of fire or electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

RISK OF FIRE OR ELECTRIC SHOCK

DO NOT OPEN

WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,

DO NOT REMOVE COVER (OR BACK)

NO USER-SERVICEABLE PARTS INSIDE

REPAIR SHOULD BE DONE BY AUTHORIZED SERVICE PERSONNEL ONLY

Safeguards

READ ALL INSTRUCTIONS.