Programming Filter, Programming economy mode

The required portion of tea-water is programmed now.

By pressing the + button, you can select the next phase, or press the N button in order to leave the programming.

13.6 Programming Filter

Please read chapter 7.1 “Placing filter“.

13.7Programming water hardness (only with setting Filter no)

HARDNESS LEVEL 3

Press key P

By pressing key + or - briefly you can programme the water hardness level.

Then press key P briefly to store the water hardness level in memory.

By pressing the + button, you can select the next phase, or press the N button in order to leave the programming.

To determine the water hardness level please read chapter 6. “Adjusting for water hardness“.

13.8 Programming economy mode

ECONOMY MODE OFF

Press key P

By briefly pressing key + or - you can programme the mode you would like.

Then press key P briefly to store mode in memory

By pressing the + button, you can select the next phase, or press the N button in order to leave the programming.

You can programme your machine to “economy mode“. In the set- ting ECONOMY MODE ON the steam heating-system is switched off. The heating for the cup warming tray is switched off too. If you want to draw off steam you need to press the steam key , warning lamps flash and your machine heats up.

After 10 minutes the steam heating-system switches off automatically. The warning lamps go out. By pressing the steam key anew, you return to stand-by-status for drawing off steam.

ECONOMY MODE OFF means that the stand-by-status for steam is set to 20 minutes and the heating for the cup warming tray is on. After 10 minutes the warning lamp goes out. By pressing the steam key anew, the machine returns to stand-by-status for drawing off steam.

13.9 Programming timer clock

A programming of the timer clock is necessary if an auto- matic switch on time is required.

TIME —.—

Press key P .

By briefly pressing key + or - you can set the hours and then confirm by pressing key P .

By briefly pressing key + or - you can set the minutes and then confirm by pressing key P .

By pressing the + button, you can select the next phase, or press the N button in order to leave the programming.