Maintenance

Cleaning is the only maintenance normally required. It must be carried out with the microwave oven disconnected.

Do not use metal scouring pads on the inside of the oven cavity. They will scratch the surface.

At regular intervals, especially if spillovers have occurred, remove the turn-table and wipe clean the base of the oven.

This oven is designed to operate with the turn-table in place.

Do not operate the microwave oven when the turn-table is removed for cleaning.

Use a mild detergent, water and a soft cloth to clean the interior surfaces front and rear of the door and the door opening.

Do not allow grease or food particles to build up around the door.

For stubborn soil, boil a cup of water in the oven for 2 or 3 minutes. Steam will soften the soil.

Odours inside the oven can be eliminated by placing a cup of water with lemon juice added into the oven and boiling the mixture.

Important:

The door seals and the door seal areas must be regularly inspected for damage. If these areas are damaged the appliance should not be operated until it has been repaired by a service technician trained by the manufacturer.

WARNING!

Abrasive cleaners, steel-wool pads, gritty wash cloths, etc can damage the control panel, and the interior and exterior oven surfaces. Use a sponge with a mild detergent or paper towel with spry glass cleaner. Apply spray glass cleaner to paper towel.

Do not spray directly on the oven

Service

If the oven does not work, do not make a service call until youhave made the following checks:

*The Turn-table and turn-table support is in place.

*The Plug is properly inserted in the wall socket.

*The Door is properly closed.

*Check your Fuses and make sure that there is power available.

*Wait for ten minutes and then try to operate the oven once more.

This is to avoid unnecessary calls for which you will be charged.

When calling for Service, please give the serial number and type number of the oven (see Service label).

Important:

If the mains cord needs replacing it should be replaced by the original mains cord which is available via our service organisation. The mains cord must only be replaced by a trained service technician.

WARNING!

Service only to be carried out by a service technician trained by the manufacture. It is dangerous for anyone other than a service technician trained by the manufacture to perform repair service.

Technical specifications

Model	PMO-500
Supply voltage	240V / 50Hz
Current consumption	1250 W
Fuse	10A
Microwave power i(acc. to IEC 705. 1000g water)
Full power	750 W
Timer	Mechnical
Dimensions (Height x Width x Depth) in mm
Outside dimensions	286 x 463 x 339
Oven cavity dimensions	249 x 276 x 264