OmniTek OmniTek XR manual Output Menu, Full Screen Menu

Page 14

Output Menu

This menu controls features relating to the output video.

OmniTek XR can display a crosshair on the output. The crosshair is always centred over the sample currently displayed in the dataview. The crosshair can appear on the analogue (monitoring) output, or the serial digital output, or on both outputs.

XR can detect when the incoming video is out of range, based on the range thresholds set up in the Engineering menu (see page 20 for details), and key out any erroneous pixels and replace them with a flashing black and white pattern. This error display can be included on the analogue output, the digital output, or both outputs. The menu selection determines which output is used to display the flashing pattern. Note that range errors can also be highlighted onto the YUV waveforms. The same thresholds are used to determine out of range, but the choice of highlighting is set on the Options/Data menu, from within the waveform window.

Similarly, XR can detect when the incoming video (YUV data) is outside of valid RGB colour space. Again out of gamut pixels can be highlighted on either output with the flashing pattern. In the same way, out of gamut pixels can also be shown on the RGB waveforms. Note it is not possible to highlight pixels with range errors and pixels with gamut errors simultaneously on the waveforms, as pixels with range errors can only be seen when displaying YUV waveforms, and pixels with gamut errors can only be seen when displaying RGB waveforms.

Full Screen Menu

Page 14

Image 14
Contents OmniTek XR Page Table of Contents XR Windows Index Introduction From Power-UpUser Guide Quick Start GuideVideo Setup Windows LayoutImage Choice Menus Detailed User GuideOpening Window Description File MenuPreferences Windows Layouts, and SnapshotsShow Menu Configuration Menu Run MenuAnalyzer Menu Output Menu Full Screen MenuInstructions for the use of the Layout Builder Assigning Settings About Menu Engineering Controls part of Configuration menuWindow Menu Engineering Video GeneralSync Type/Position Reprogram FlashSet Video Standard Monitoring OutputPower on Defaults Engineering Video Analyzer Engineering Video Dual Link Option Engineering Audio Error Detection Engineering Timecode Reader Configuration Engineering PictureEngineering Video Index Reader Configuration Page Engineering Teletext Detector Configuration Toolbar Icons Run Transport Toolbar with Motion/Capture optionSequence play controls Source Toolbar Source Toolbar Dual Link OptionMain Toolbar Page Page Video Standard Toolbar Crosshair ToolbarCursor Toolbar Page XR Windows Waveform Window+ RGB Options Menu Page Page Colour Mode menu Histogram WindowVectorscope Window Page Region of Interest Window Mini-Pic Window Window Controls SnapCage Generator Page Video Checking Features Video Status/Error detectionGeneral video status parameters Teletext Detection SD only Timecode Checking Audio Checking Features Generator Window File MenuPattern Menu View MenuSource Menu Window MenuIe frames in the OmniTek RVF format Pattern Creation How to import Frame patternsHow to import Sequences Frame based patternsHow to Grab Images Motion/Capture option only Full Frame Record/Playback Advanced Option only Important NoteRVF File Editor Advanced Option only Pattern MenuFile Monitor Function Generator Playlists Video/audio generator settings for this item Add/Edit itemPlaylist save/open/new Item orderDelete item Page Status Bar Other FeaturesMiscellaneous Features Presets A1 File Types JpegA2 Logging Configuring Logging, and Snmp alertsLogging Configuration and use Page Snmp Configuration and use Snmp Configuration ProblemsPage A3Measuring Audio/Video Delays Delay Test SequenceLoop A/V Delay Testing OmniTek SystemRelative A/V Delay Testing Transmission PathSetting up the OmniTek System Gen SetupView Setup Index DetectionToolbar