5 Video Checking Features
Introduction
OmniTek XR has the ability to display
Video Status/Error detection
The Video status box has two main modes of operation. This is Report View, and normal view. In report view, there are no buttons on the Video Status window, so it only reports information. In the normal view, there are reset buttons for all error counters, error mode buttons, and alarm enable buttons, together with a global reset, global error mode and global alarm enable mode. Selecting ‘Report View’ from the Options menu toggles between these two modes.
The Reset error count menu selection lets you reset all counters, or specific ones as required.
The number of errors since the error counters were last reset is displayed in the video status box. For each error condition, there are various display modes available. You can cycle through the available options by repeatedly pressing the mode button. Note that the mode button looks slightly different depending on the current mode. This function is duplicated by the ‘Toggle error count states’ menu selection.
Display modes are -
Show the total number of errors. The number will be displayed in green whilst the count is 0, and be red if there are errors.
Display the word 'Error' in red text for 0.5 seconds after an error is detected, then revert to showing 'OK' in green text.
Display the elapsed time since the last error. The text will be green if the error count is 0, and red otherwise.
Display the number of errors detected per unit of time. The unit used for time will vary depend on the actual error rate.
Clicking the red 
resets the individual error count. Alternatively, you may click the red 
at the very bottom of the window to reset all error counters.
Page 48