Saeco Coffee Makers CAP001/A manual Using the Machine

English

6 - USING THE MACHINE

Important

Before operating the machine it is necessary to have read this publication carefully and to have gained a good general knowledge of the machine.

After a period of inactivity of the machine it is advisable to read again chapter “5.3 before re-utilising the machine.

6.1Machine statuses

Concerning the electricity mains, the machine can be found in one of the following statuses:

Machine off and cut out

-Main switch (ref. 10, fig. 1) and all-pole switch in position “0“ or plug disconnected.

-Only the stored data memory is active.

Machine on

-Main switch (ref. 10, fig. 1) and all-pole switch in position “I“ or plug connected.

-All functions are active and display (ref. 8a, fig. 1) is on.

Standby mode (machine off but not cut out)

-Main switch (ref. 10, fig. 1) in position “I“.

-Functions “AUTOMATIC OPERATION”, “ANTIFREEZ- ING”, are active if selected, and “CLOCK”, as well as the display and stored data memory.

-Diplay backlighting is off.

6.2Manual switching on

This type of starting up is required when the machine is in the “machine off and cut out” status (see 6.1 Machine statuses). It is necessary to proceed as described in “5.3 First switching on” by disconnecting the dispensed drink command, if possible.

6.3Programmed automatic switching on

It is possible when the machine is in “STANDBY” mode and the function “AUTOMATIC OPERATION” is active

The machine will switch on at the preset time.

10

6.4Temporary switching on from standby

It is a manual and voluntary start, controlled by the User with the machine in “STANDBY” mode.

It is obtained by pressing key for 3 seconds.

The machine will revert automatically to the “STANDBY” mode 60 minutes after the last operation performed.

6.5Coffee dispensing

Briefly press (less than 1 sec.):

-keyto obtain a single small cup, the display will show “1 SMALL CUP”;

or

- key to obtain two small cups (a double dose of cof- fee is used), the display will show “2 SMALL CUPS”;

or

-keyto obtain a single large cup, the display will show “1

LARGE CUP”;

or

- key to obtain two large cups (a double dose of cof- fee is used), the display will show “2 LARGE CUPS”.

All these types of dispensing are obtained from coffee that is in- stantly ground by the machine.

During the dispensing, the display will show “PREINFUSION”, if enabled by menu (see “6.14 Menu-programmable functions”); beside the message, an icon with a cup being filled will be dis- played.

When the dispensing is over the display will show “READY FOR USE”.

6.6Pre-ground coffee dispensing

Use pre-ground coffee instantly loaded into the machine for pre- ground coffee dispensing.

-Briefly press (less than 1 sec.) key once. The display will show “PRE-GROUND”.

-Use the specific measuring spoon to introduce one dose of pre-ground coffee through the pre-ground coffee slot (ref. 6, fig. 1).

-Press key or .

The machine will behave as for a normal dispensing, utilising the dose of pre-ground coffee manually introduced.

N.B.: Dispensing with pre-ground coffee is programmable only for one dose.