Saeco Coffee Makers CAP001/A manual Installation, Coffee dispenser unit, Connections

4.3Coffee dispenser unit

The position of this unit (ref. 21, fig. 4) can be modified accord- ing to the height of the container used.

In fact it is possible to move the mobile dispenser backwards (ref. 23, fig. 4) and the telescopic dispenser upwards or downwards (ref. 24, fig. 4).

This allows different heights to be obtained.(see fig. 4).

N.B.: If a container taller than 90 mm is always and exclusively used, the telescopic dispenser can be removed altogether (ref. 23, fig. 4), by drawing it downwards.

fig. 4		21
		23
		24
100 mm	60 mm	150 mm

4.4Steam/hot water spout (LUXE version)

The steam (ref. 16, fig. 1) and hot water spouts (ref. 11, fig. 1) are equipped with suitable rubber protectors (ref. 14 and 9, fig.

1)so that they can be easily gripped and moved even when over- heated.

English

5 - INSTALLATION

Danger

Operation falling within the competence of the Maintenance technician.

5.1Connections

Warning

The connection will have to be implemented by observing the national safety rules

Carry out connections as follows:

-Check that the surface upon which the machine is placed is firm and able to withstand the weight.

-Drill the relevant holes in the surface top (ref. C’ and D’ or F’, fig. 6), and possibly also the other holes (ref. B’, fig. 6 e ref. E’, fig. 6 - see N.B.), as indicated in the drawing.

-Install the machine on the surface and level it by adjusting the feet made available for this operation (ref. A, fig. 5).

-Connect machine to the drinking water system by way of the special fitting (ref. C, fig. 5).

WATER AND WASTE CONNECTIONS SHALL COMPLHY WITH APPLICABLE FEDERAL STATES, OR LOCAL CODES. (Only for USA and CDN models)

-Connect to the power mains by way of the relevant cord (ref. D, fig. 5).

N.B.: It is possible to connect the drip tray (ref. 15, fig. 1) directly to an outlet by proceeding as follows:

-drill the surface top as indicated (ref. B’, fig. 6);

-break the removable diaphragm which seals the drip tray outlet (ref. 15, fig. 1);

-join a drain tube to the fitting (ref. B, fig. 5), by way of a suitable hose clamp.

	A
A
D
C
E
	A
	B
fig. 5	A
	7