Radio Shack LK-1500 owner manual U c h, Using Touch Response, About Function button

Keyboard Settings

NOTE		2 Use the [+] and [–] or [0] and [1] buttons to change
•	The keyboard can be transposed within a range of –12	the setting.
	(one octave downwards) to +12 (one octave upwards).	Example: To select touch response 2.
•	The default transpose setting is “00” when keyboard

	power is turned on.
				T o u c h
•	If you leave the transpose screen on the display for about
	five seconds without doing anything, the screen is
	automatically cleared.
•	The transpose setting also affects playback from memory	• Touch response is on when TOUCH RESPONSE
	and Auto Accompaniment.
			indicator is on.

•To return the keyboard to its default key, perform the

above procedure and press both of the KEY CONTROL/
TRANSPOSE buttons ( and ) at the same time in
step 2. You could also use the [+] and [–] buttons to
change the transpose setting to “00”.
• The effect of a transpose operation depends on the pitch
of each note and on the tone you are currently using. If
a transpose operation causes a note to be outside of
the allowable range for a tone, the same note in the	Indicator appears
nearest octave within the range will be substituted.	• Touch response is off when TOUCH RESPONSE
	indicator is off.

Using Touch Response
When touch response is turned on, the relative volume of
sound output by the keyboard is varied in accordance with
the amount of pressure applied, just like an acoustic piano.
Touch response provides a choice of three settings, described
below.	NOTE
OFF: This setting turns off touch response. Keyboard pressure	•	Touch response not only affects the keyboard’s internal
does not have any affect on the output notes.		sound source, it also is output as sending message.
1: This setting provides touch response that is suited for	•	Song memory playback and accompaniment do not
		affect the touch response setting.
normal play.

2: This setting increases touch response, so stronger keyboard
pressure has a greater effect than the “1” setting.	About FUNCTION button
1 Press the FUNCTION button until the TOUCH	Each press of the FUNCTION button cycles through a total
RESPONSE SELECT screen appears.	of 10 setting screens. If you accidentally pass the screen you
	want to use, keep pressing the FUNCTION button until the
	screen appears again.

T o u c h

E-48 649U-E-050A