Section One: General Safety Instructions
SAFETY
ELECTRICAL REQUIREMENTS AND GROUNDING INSTRUCTIONS
PLEASE READ CAREFULLY
All Cooktop models and the Wok require an elec- trical circuit rated at 120 volts, 60 Hz., 15 Amps.
For personal safety, this appliance must be connected to a properly grounded and polarized electrical power supply.
Always disconnect the electrical plug from the wall receptacle before servicing this unit.
See Installation Instructions for electrical requirements and grounding instructions.
DO NOT UNDER ANY CIRCUMSTANCES CUT OR REMOVE THE SEPARATE GROUND WIRE OR THE THIRD (GROUND) PRONG FROM THE POWER CORD PLUG.
It is the personal responsibility and obligation of you, the user, to have this appliance connected to the electrical power supply in accordance with the National Electrical Code and/or applicable local codes and ordinances by a qualified electrician.
It is recommended that a dedicated circuit servic- ing this appliance be provided.
! CAUTION - ALL MODELS
In Case of an Electrical Failure
If for any reason a gas control knob is turned ON and there is no electric power to operate the electronic igniters on the cooktop burners, turn OFF the gas control knob and wait 5 minutes for the gas to dissipate before lighting the cooktop burner manually.
To light the cooktop burners and grill manually, carefully hold a lighted match to the burner ports and turn the gas control knob to HI. During a power failure, you can manually light the standard cooktop burners and grill only, but each must be lit with a match.
If the grill is left on and power is restored, the grill will relight.
DO NOT attempt to light the two left burners manually.These burners are equipped with the ExtraLow® feature and cannot be lit manually.
See Pages 11 and 29 for additional information on manually lighting the burners.
Page 2