Tribest FS-610 manual HOWow toTOassembleASSEMBLE

Page 5

HOWow toTOassembleASSEMBLE

Assemble the entire juicing unit [Vertical Auger + Juicing Screen + Pulp Wiping Assembly +

Placel tthe screwVerticalintoAugera centerinto ofthestrainercenter. of the Juicing Screen. Then place the Juicing

* Spin and push the juicing screw while inserting into

Screen into the Pulp Wiping Assembly. the strainer.

Turn and push down the Juicing Screen

while inserting it into the Pulp Wiping Assembly.

ScrInsertw (Vertical+ StrainerAuger+ Rotation+ JuicingwiperScreen

+Pulp Wiping Assembly) into the Auger

Make sure the red dots are aligned.

Housing.

Make sure the red dot on the Juicing Screen and the red dot on the Auger Housing are aligned.

Red Dot on Strainer assemble Juicing Screen mark

RedJuicingDotbonwl

Auger Housing

assemble mark

Vertical Auger

JuicingStrainerScreen

Pulp Wiping Assembly

Auger housing +Feeding Chute Assembly] to the Main Body. Locate the small white arrow on

Assemble the entire top set onto the base. As shown above, assemble the bowl onto the the rear side of the Auger Housing Lid and set it to meet the arrow at “Open” position on the base and twist the bowl so that the lid edge in pointing to ‘close’ sign.

rear top of the Main Body.

Turnrow atthe“Close”id towardspositioncloseof themarkMain. Body. Make sure the aligning mark at “Close” position on the Auger Housing lid and the red dot on the Auger Housing are exactly aligned.Turn the Auger Housing clock-wise until the arrow on the Auger Housing Lid aligns to the ar-

3

Connect the Feeding Chute Assembly to

4

Turn the Feeding Chute Assembly clockwise

Connect the lid and the bowl through

By turning it the clock-wise, make sure

the Auger Housing. Align the mark of the

until the mark of the “CLOSE” position aligns

the red spot

assembles mark and

the spot on the lid and the red spot

 

“OPEN” position on the Auger Housing Lid

 

to the red dot on the Auger Housing.

 

assemble it.

 

 

on the bowl is aligned.

 

to the red dot on the Auger housing.

 

 

 

 

 

 

Auger

 

 

 

 

Housing Lid

Align mark at Assembly position “OPEN” position mark

on the Auger Housing Lid

Auger

Housing

Red Dot on Juicing bowl Auger Housing assemble mark



Properly place the Juice Container

Place the juice cup properly.

and Pulp Container at the base of the

 

juice/pulp spouts.

›

Image 5
Contents Fruit & Vegetable Juicer Contents Water Ngers into the appliance while the cord is pluggedAppliance Do not keep or operate the appliance nearPowerful motor, no heat build-up FEATURESeatures PARTSarts nameNAMEHandgrip for ease of use Vertical AugerHOWow toTOassembleASSEMBLE HOWow to use the juicer Push down the switch to start operatingTimes MachineDissemble Counter-clockwise Lift it by picking like arrow toDissemble the parts reverse way CordTail Like the picture next to itPlease cut the carrot into the right size to insert RECIPESecipesfforFORJuicejuiceJUICEInsert the tomatoes into the appliance Status Check list TROUBLESHOOTINGQ&AroubleshootingMemo SPECIFICATIONScationNTYy Please read carefullyCompress type. Low speed compression Cation