16 THE INFO MODE
Making a Copy of the Oven Menu
To save a copy of the oven menu to a smart card,
1.Insert the smart card (Figure 26).
2.Press the L2 soft key (Figure 27).
3.Verify the oven beeps and reads “FINISHED”.
To save a copy of the oven menu to a USB drive,
1.Insert the USB drive (Figure 26).
2.Press the L5 soft key (Figure 27).
3.Verify the oven beeps and reads “FINISHED”.
Updating the Oven Firmware
Perform this procedure only when an update to the operating system is required. For menu updates, see page 15.
From the Oven Off screen,
1.Insert the smart card (see Figure 26). If multiple smart cards are required, ensure the correct smart card is loaded first.
2.From the COOLING DOWN or OVEN OFF mode,
press and hold the Info key until the oven resets (approximately 5 seconds).
3.When the oven beeps one long high tone, the load was successful. Insert the second card.
4.When the oven restarts and the display turns on, the update is complete. Remove the smart card.
NOTE: If the update is unsuccessful, the display will remain off and the oven will beep one long, low tone. If this occurs, repeat the above proce- dure. If the update fails multiple times, contact TurboChef as a card may be damaged or the version may be incorrect.
CAUTION: The oven will be inoperable if the firmware update is unsuccessful!
Smart Card
USB Port
Smart Card Reader Slot
Figure 26: Inserting Smart Card/USB Device
L1 | LOAD FROM CARD | R1 |
L2 | SAVE TO CARD | R2 |
L3 |
| R3 |
L4 | LOAD FROM USB | R4 |
|
| |
L5 | SAVE TO USB | R5 |
|
Figure 27: Load Menu Screen
L1 | LOAD FROM CARD ++++++++FINISHED | R1 |
L2 | SAVE TO CARD | R2 |
L3 |
| R3 |
L4 | LOAD FROM USB | R4 |
|
| |
L5 | SAVE TO USB | R5 |
|