Appendix Flags list | 2Wire AU5400, AU2700 guide

A.Appendix

(1) Flags list

Flag	Contents
(	Failed to evade the contamination since the detergent for evading the contamination is not enough.

%	The sample probe is clogged with sample.

?	Calculation unable due to abnormal photometric data

#	Sample level detection error
R	Reagent level detection error
!	Calculation unable due to abnormal data
	Reagent absorbance value at P-START of Reagent Blank run, is smaller than the
U	Lower limit of the Parameter.
	Reagent absorbance value at P-START is lower than the lower limit specified
u	In the Parameters in routine run.
	Reagent absorbance value at P-END of Reagent Blank run, is greater than the
Y	Upper limit of the Parameter.
	Reagent absorbance value at P-END is higher than the upper limit specified
y	In the Parameters in routine run.
@	Abnormally high result; absorbance of every wavelength is more than 2.5.
$	No linearity validation conducted because less than 3 data obtained in the
	Kinetics.
D	Too quick reaction slope in increasing kinetics, absorbance at P-START is
	Higher than MAX. OD in increasing FIXED assay, or too slow reaction slope
	In decreasing kinetics (= no reaction observed)
B	Too quick reaction slope in increasing kinetics, or absorbance at P-END is
	Lower than MIN. OD in increasing FIXED assay.
	Linearity error in kinetics.
*	Linearity error in kinetics.
&	Prozone data error (prozone check point data error)
Z	Prozone error
F	Result higher than the dynamic range specified in the Parameters
G	Result lower than the dynamic range specified in the Parameters
x	Other QC data error
1	QC result beyond the QC value range specified in the Parameters
2	Multi-rule QC data error
3	Multi-rule QC data error
4	Multi-rule QC data error
5	Multi-rule QC data error
6	Multi-rule QC data error
7	Multi-rule QC data error
p	Result beyond the panic value specified in the Parameters
T	Abnormality found in the Inter-Item Check
P	Result higher than DECIDE RANGE designated in parameters.
N	Result lower than DECIDE RANGE designated in parameters.
H	Higher than the result value range specified in the Parameters
L	Lower than the result value range specified in the Parameters
J	Result higher than the repeat run range specified in the Parameters
K	Result lower than the repeat run range specified in the Parameters
S	Result extracted for repeat run

- 44 -