Care & Cleaning
Door Hinge
locations
with oven door
fully open
Figure 1
Figure 2
Around
Oven door
Hinge
Figure 3
Roller pin
Hinge arm hook
Hinge arm notch
Slot bottom
Figure 4
Changing Oven Light
Be sure the oven is unplugged and all parts are COOL before replacing the oven light bulb. Do not turn the oven light on during the
On some models an interior oven light will turn on auto- matically when the oven door is opened.
The oven light may be turned on when the door is closed by using the oven light switch located on the control panel.
On a self clean oven the lamp is covered with a glass shield held in place by a wire holder.
THIS GLASS SHIELD MUST BE IN PLACE WHENEVER THE OVEN IS IN USE.
To replace the light bulb:
CAUTION: BE SURE OVEN IS COOL
1.Turn the power off at the main source.
2.Wear a
glove for protection against possible broken glass.
3.Replace bulb with a 40 watt appliance bulb only.
4.For
wire holder to one side to release glass shield, change bulb and be sure to replace glass shield.
Storage Drawer
Use the storage drawer for storing cooking utensils. The drawer can de removed to facilitate cleaning under the range. Use care when handling the drawer.
Removing and Replacing Storage Drawer
To remove the drawer:
1.Pull empty drawer out to the roller guide stop.
2.Tilt the drawer up and pull it out over the rollers.
To replace the drawer:
1.Insert the rear end of the drawer into the opening.
2.Fit the drawer end rollers onto the guide rails.
3.Push the drawer in until it stops, then lift to allow the rollers to clear the roller guide stop, and push in.
Roller Storage
Drawer
Roller
Guide
Front Frame
29