Kenmore 790.467 manual Setting Oven Controls, Setting the Clock, Instructions, Display

Setting Oven Controls

Setting the Clock

The _-_ pad is used to set the clock. The clock may be set for 12 or 24 hour time of day

operation. The clock has been preset at the factory for the 12 hour operation. When the range is first plugged in, or when the power supply to the range has been interrupted, the timer in the display will flash with "PF" (power failure, See Figure 1).

When PF appears in the display, press _,	PF will disappear.
',,,..)

INSTRUCTIONS

To set the cJock (example below for 1:30)

1.Press ___. "CLO" will appear in the display (Figure 2).

2. Press C. ) (_ _ pads to set the time of day to 1:30

(Figure 3). "CLO" will stay in the display. Press I}_TAR._"CLO"

will disappear and the clock will start (Figure 4).

PRESS

@

qb( db

Figure 1

DISPLAY

Figure 2

Changing between 12 or 24 hour time of day display

1.Press and hold (_) for 7 seconds. "CLO" will appear in the

display. After 3 seconds I_ will appear in the display indicating that the cooktop lockout is active (Figure 5). CONTINUE holding the pad until "12h" (Figure 6) or "24h" (Figure 7) appears in the display and the control beeps once.

2.	Press _	to switch between the 12 and 24 hour	time of day
	display. The display will show either "12h" (Figure 6) or "24h"
	(Figure	7).
3.	Press	to accept the change or press	to reject the

for 7 seconds

Q

_: START 01"

Figure 3

Figure 4

Figure 5

change. I_1will disappear from the display.

4.Reset the correct time as described in To set the Clock above. Please note that if the 24 hour time of day mode was chosen, the clock will now display time from 0:00 through 23:59 hours.

Figure 6

Figure 7

15