Kenmore 790.9270 Setting Oven Controls, Setting Clock, Add I Minute, Hour Energy Saving feature

Setting Oven Controls

Setting Clock

When the appliance is first powered up, ]2:00 wiil flash in the display (See Fig. 1). The time of day must first be set before operating the oven.

Fig. ]

Example; to set the clock to 1:30:

1.Press (_) key pad.

2.Enter 3 0 using numeric key pads.

3.Press ;START *

Important note:

The clock cannot be changed when a Cool< Time or Delay Start feature is active.

Setting Timer

The minute timer allows you to track your cooking times without interferring with the cooking process. The timer may be set from ] minute up to 11 hours and 59 minutes.

Example; to set the timer for 5 minutes:

1.Press Timer Set/Off key pad.

2.Enter 5 using numeric key pad.

3.Press STARTkey pad to start timer.

To cancel the timer when active press Timer Set/Off key pad again.

Important notes:

*The timer does not start or stop the cooking process. It serves as an extra minute timer in the kitchen that will beep when the set time has run out. The timer may be used alone or while using any of the other oven functions.

The timer wiii display hours and minutes until I hour remains. When less than ] hour remains, the display wiii count down in minutes and seconds. Once the timer has less than ] minute remaining only seconds wiii display.

When the timer is active during a cooking process, the minute timer will show in the display. To view the information of any other active oven function, press the key pad once for the other function to view the status.

Add I Minute

Use the Add ] Minute to set additional minutes to the timer. Each press of the key pad wili add ] additional minute. If Add ] Minute key pad is pressed when the timer is not active, the timer wili activate and begin counting down from ] minute.

Example; to add 2 minutes to the timer:

Press Add I Minute key pad twice.

Setting 12 or 24 hour display mode

The clock display mode allows you to choose between 12 or 24 hr modes. The factory pre-set clock display mode is

12hours.

Example; to set 12 or 24 hour display mode:

1.Press and hold _ key pad for 6 seconds.

2.Press Flex (::lean key pad to toggle between 12 hour (Fig. 2) or 24 hour (Fig. 3) display modes.

3.Press ST_ tO accept choice.

Fig. 2 Fig. 3

Changing between continuous bake setting or

12-Hour Energy Saving feature

The oven control has a factory preset built-in 12 Hour Energy Saving feature that will turn off the oven if the oven is left on for more than 12 hours. The control may be programmed to override this feature to continuously bake.

Example; to change between continuous bake or 2-Hour Energy Saving feature:

1.Press and hold Timer Set/Off key pad for 6 seconds.

2.Press Flex Clean to toggle between 12 Hour Energy Saving (Fig. 4) or continuous bake (Fig. 5) feature.

3.Press STA_ tO accept choice.

Fig. 4 Fig. 5

]6