Setting Surface Controls
Surface element settings
The size and type of utensil used, and the amount and type of food being cooked will influence the surface element power level setting needed for best cooking results.
The suggested settings found in Fig. 1 below are based
when cooking with
Suggested settings far surface elements
Settings | Type of cooking |
High (HI - 9)Start most foods, bring water to a boil, pan broiling
Medium high (7 - 8) Continue a rapid boil, fry, deep
fat fry
Medium (5 - 6)Maintain a slow boil, thicken sauces and gravies or steam vegetables
Medium Low (2 - 4) Keep foods cooking, poach, stew
Low (LO - 1) | Keep warm, | melt, simmer | |
| Fig. | 1 |
|
1!]_[][]_ | Surface elements | may | appear to have |
cooled after they have been turned off. The surface element may still be hot and burns may occur if the surface element is touched before it has cooled sufficiently.
_i_Do not place plastic items such as salt and pepper shakers, spoon holders or plastic wrappings on tap of the range when it is in use. These items could melt or ignite. Potholders, towels or wooden spoons could catch fire if placed too close to the surface elements.
Fig. 2
To operate the single radiant element:
1.Place correctly sized cookware on surface element.
2.Push in and turn the surface control knob in either direction to the desired setting (See Fig. 2).
3.When cooking is complete, turn the surface element OFF before removing the cookware.
Important notes:
"The surface control knobs do not have to be set exactly on a particular spot. Use the graphics provided as a guide and adjust the control knob as needed. Refer to Fig. 1 for suggested power level settings.
"Start most cooking operations on a higher setting and then turn to a lower setting to finish cooking.
The ELEMENT ON indicator light(s) will glow when one or more surface elements are turned ON. A quick glance at this indicator light when finished surface cooking is an easy check to be sure all surface controls are turned OFF.
10