Precision Power D3000/1, D2000/1 Qbass Plustm, Optional QBASS REMOTETM, Qbass Plus Specifications

Page 17

QBASS PLUS SPECIFICATIONS

QBASS PLUS SPECIFICATIONS

QBASS PLUSTM

Up to 18dB of boost with selectable center frequency at 30Hz, 36Hz, 44Hz or 60Hz, with a Q-factor of 2.

Optional QBASS REMOTETM

This boost control can be mounted in the dash and will supersede the boost control on the amplifier endplate.

16

Image 17

Contents D500/1 AMPLIFIER MODELSD1000/1 D2000/1TABLE OF CONTENTS CONGRATULATIONS SERVICEWHAT’S INCLUDED FEATURESCEA SPECIFICATIONS Nominal Power Ratings SPECIFICATIONSGeneral Specifications D500/1Fuse The LEDs provide the following indications Small flat blade screwdriver When using 16 gauge wire or larger, run the speaker wires from the amplifier location through the vehicle to the speakers. Observe the same precautions for routing these wires that you followed for running the power and remote turn on wires. Cut off excess and, using wire strippers, strip 1/4-inchof insulation. Locate the speaker/remote turn- on PowerLockTM connector. Using a hex wrench loosen the screws on the upperside of the connector. Insert the speaker leads into the end and secure with the hex wrench. Check to be sure youve maintained proper polarity before securing each wire POWERLOCKTM Total RMS output X 1.3 = Total Input Wattage 1300W= 108 Amps total current draw 12V POWERLOCK CONNECTORS Power wires3mm hex wrenchXOVER FRONT PLATE DIAGRAMSD2000/1, D3000/1 END PLATE DIAGRAMS12 D500/1, D1000/1 SOURCE Headunit INPUTSADVANCED INSTRUMENTATION INPUT QBASS PLUS SPECIFICATIONS QBASS PLUSTMOptional QBASS REMOTETM QBASSTM Settings TC-XCROSSOVER D500/1, D1000/1, D2000/1, and D3000/1CROSSOVER DETENT CHART TROUBLESHOOTING ADJUSTING INPUT GAINHIGH MASS INTERNAL HEATSINK AP-IVPROTECTION CIRCUITOPPOSITE CHANNEL Precision PowerTM Dealer orSAME CHANNEL OPPOSITE CHANNELLIMITED TWO YEAR CONSUMER WARRANTY