Precision Power manual End Plate Diagrams, 12 D500/1, D1000/1, D2000/1, D3000/1

Page 15

END PLATE DIAGRAMS

12.-12dB Input Attenuation: Push this switch ‘IN’ for high voltage

(4V-12V) capability. This button pushed ‘IN’ must be used for speaker level input on common ground head-units or for high voltage line drivers.

13.Phase: These switch sets the phase of the output relative to the amplifier input.

14.RCA Outputs: RCA outputs provide HP/LP/FULL 30-4kHz signal to another amplifier.

END PLATE DIAGRAMS

12

D500/1, D1000/1

QBASS

REMOTE

1	1	2
D2000/1, D3000/1
		QBASS
		REMOTE

3	4
+18	0
QBASS

3	4
+18	0
QBASS

1.Power/Ground PowerLockTM: Note that the D2000/1 and D3000/1 have two of these receptacles. You must connect the power and ground cables to both PowerLockTM terminals for optimum operation.

2.QBASS REMOTETM: Plug in the data cable from the optional QBASS REMOTETM dash mounted level control here. (The remote level control will bypass the amplifier’s on board QBASSTM control.

3.QBASSTM Level Control: Controls bass boost, centered at 40Hz with up to 18dB of boost.

14

Image 15

Contents D2000/1 AMPLIFIER MODELSD500/1 D1000/1TABLE OF CONTENTS CONGRATULATIONS SERVICEFEATURES CEA SPECIFICATIONSWHAT’S INCLUDED D500/1 SPECIFICATIONSNominal Power Ratings General SpecificationsFuse The LEDs provide the following indications Small flat blade screwdriver When using 16 gauge wire or larger, run the speaker wires from the amplifier location through the vehicle to the speakers. Observe the same precautions for routing these wires that you followed for running the power and remote turn on wires. Cut off excess and, using wire strippers, strip 1/4-inchof insulation. Locate the speaker/remote turn- on PowerLockTM connector. Using a hex wrench loosen the screws on the upperside of the connector. Insert the speaker leads into the end and secure with the hex wrench. Check to be sure youve maintained proper polarity before securing each wire POWERLOCKTM Total RMS output X 1.3 = Total Input Wattage 1300W= 108 Amps total current draw 12V wrench Power wiresPOWERLOCK CONNECTORS 3mm hexXOVER FRONT PLATE DIAGRAMSEND PLATE DIAGRAMS 12 D500/1, D1000/1D2000/1, D3000/1 INPUTS ADVANCED INSTRUMENTATION INPUTSOURCE Headunit QBASS PLUSTM Optional QBASS REMOTETMQBASS PLUS SPECIFICATIONS QBASSTM Settings TC-XCROSSOVER D500/1, D1000/1, D2000/1, and D3000/1CROSSOVER DETENT CHART AP-IVPROTECTION CIRCUIT ADJUSTING INPUT GAINTROUBLESHOOTING HIGH MASS INTERNAL HEATSINKOPPOSITE CHANNEL Precision PowerTM Dealer orOPPOSITE CHANNEL SAME CHANNELLIMITED TWO YEAR CONSUMER WARRANTY